Beon BN-8600 [7/12] Instruction manual

7 INSTRUCTION MANUAL

DEVICE DESCRIPTION

1. Housing

2. Indicator

3. Steam intensity regulator

4. Devise basement

BEFORE FIRST USE

After transporting or storing the device at a reduced temperature, it must be kept at room temperature for at

least three hours.

There may be traces of water inside the humidifier – this is normal, since the device has passed quality

control.

 Unpack the appliance and remove packaging materials and any advertising stickers, interfere

with the operation of the device. Inspect the device for damage.

 If there is damage, do not turn on the appliance.

 Before connecting to the mains, make sure that the mains voltage corresponds to the operating

voltage of the appliance.

 The device is designed to operate in an AC network with a frequency of 50 Hz, no setting is

required to operate the device at the required rated frequency.

Notes:

– Use the humidifier when the room temperature is between +10°C and +40°C and the relative

humidity is less than 80%.

– The temperature of the water used should not be higher than +40°C.

OPERATION OF THE HUMIDIFIER

 Remove the cover with a hole for the output pair from the tank.

 Remove the tank from the device body.

 Turn the tank over and remove the lid by turning it counterclockwise.

 Fill the tank with the required amount of water, insert the lid into the water filling hole and

turn it clockwise.

 Install the filled tank on the device body and replace the cover.

 Plug the power cord into a wall outlet.

 Turn on the humidifier by turning the knob clockwise, and the power indicator will turn green.

 Set the "steam" output intensity by turning the knob.

 When the tank runs out of water, the indicator lights up red.

 Turn off the humidifier by turning the knob counterclockwise until it stops, and the indicator

will turn off. Unplug the power cord from the wall outlet.

 Fill the tank (2) with water, replace it, and turn on the device.

 When finished, turn off the humidifier by turning the knob counterclockwise pull the power

cord out of the socket until the arrows stop and the indicator light goes out.