Timberk T-HU4-A16M-W Инструкция по эксплуатации онлайн [19/44] 635837

IM2021

5. CLEANING AND MAINTENANCE

 Before cleaning the appliance, make sure it is unplugged. Otherwise, it may result

in electric shock.

 Before cleaning, in order not to burn your hands, wait until the water in the base of

the appliance has completely cooled.

 Use a damp and soft cloth to wipe the outside of the appliance.

 To avoid electric shock, do not scratch or damage the components of the device

when cleaning.

 Do not use solvent, gasoline, dimethylbenzene, hard brush, talcum powder and

other substances when cleaning the device.

 Wipe off any remaining water inside the base of the unit under the tank with a

damp and soft cloth.

 To remove water on small parts, you can use a brush and then wipe them again

with a soft cloth.

 Clean the device once or twice a week.

 If dirt is formed on the membrane, clean it with a brush.

 Rinse the water tank cover and nozzle carefully and effortlessly with fresh water,

otherwise this will cause water to leak through the cover.

 After removing any remaining water from the surface of nozzle, wipe it with a soft

cloth.

 Clean the outside of the appliance with a damp and soft cloth.

IMPORTANT!

 To avoid deformation of working surfaces, resulting in decreased atomizing or

other malfunctions, do not use metallic brushes, blades or talc powder to wipe the

atomizer’s surface.

 The water tank may leak after heavy impacts.

 In case of water leakage, immediately stop using the unit and contact an

authorized service center.

 To keep the unit dry, wipe the water after cleaning and dry the unit’s base and

water tank. Make sure that there is no water left inside the unit’s base and water

tank.

 Before a long break in use, dry the base and the tank, but the tank on the base and

pack the device in a plastic bag, then put it in a box.

 Store the unit in a low-humidity room.

 Storing the unit undried results in generation of mold.

To clean the water tank and parts of the base of the device from salt deposits, use

citric acid:

• for 1 liter of hot water, take 1 tablespoon of citric acid and mix well;

• pour the solution into the tank and put it on the base of the humidifier (water from the

tank will automatically fall into the base of the device);

• leave the humidifier for 10-12 hours - do not turn it on;