Hyundai H-1417 [7/15] Maintenance and care

 You may want to monitor during recording. You can adjust the sound with VOLUME control regulator. These adjustments do not affect the content of

recording.

 This deck is not suitable for recording on CHROME (IEC II) or METAL (IEV IV) type cassettes. For recording use NORMAL type cassette (IEC I) on

which the tabs have not been broken.

 At the very beginning and end of the tape, no recording will take place during the 7 seconds, when the leader tape passes the recorder heads.

 When in process of recording or playback the end of the tape is reached, the tape stops automatically and the relevant button is released.

Maintenance and care

 Check your batteries regularly, old or discharged batteries should be replaced. If the unit is not going to be used for some time or

is being run exclusively on the alternative power, remove the batteries to avoid leakage and damage.

 Electronic products of this kind should never be subjected to moisture or extreme temperatures.

 If necessary, clean the unit with a piece of cloth dampened with water only (be sure the AC power cord is disconnected from the

power supply).

 The heads and capstan are in constant contact with the moving tape. Use a small cotton bud with alcohol or special tape head cleaner to

clean these parts. Never touch the heads with anything metallic.

Clean the parts A, B, C shown on the picture after approximately 50 hours of last operation or on average once a month.

 Open the cassette door.

 Press PLAY to clean the rubber pressure roller C.

 Press PAUSE and clean the magnetic heads A and the capstan B. Close the cassette door.

Erase protection

 To prevent accidental erasing of a cassette, simply break off the two plastic tabs located on the cassette tape’s rear side.

 When a cassette with removed plastic tabs is inserted, the recording button cannot be pressed.

 If a cassette is to be erased and re-recorded at a later stage, simply cover the holes on the cassette where the tabs were removed, with a

piece of strong adhesive tape.

CD protection

 When pick up the CD disc, always hold the edge of the disc, never touch the surface of the disc, it would scratch the disc surface and

may occur sound distortion or raise reading problem.