Grundig GEBM19400BPHI [5/76] Connecting the appliance to the electricity supply

Содержание

EN Safety instructions Product must be installed by a qualified person in accordance with the regulations in force The manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorized persons which may also void the warranty Preparation of location and electrical installation for the product is under customer s responsibility The product must be installed in accordance with all local electrical regulations Before installing the product remove all the materials and documents in it and visually check if the product has any defects on it If so do not have it installed The product is heavy carry the product with at least two people The door and or handle must not be used for lifting or moving the appliance Use the lifting spaces on both sides of the product Always wear protective gloves during transport and installation Disconnect electrical connections in the area to be installed before installation The surfaces of the furniture that the oven is to be installed in must be heat resistant 100 C minimum Make sure the furniture is fixed before installing the product Do not install heat insulation strips inside the interior of the furniture that the oven is to be installed in The appliance must not be installed behind a decorative door in order to avoid overheating The dimensions given in the installation diagrams are in mm Installing the product If the product will be placed under the counter Figure 2 In order to provide the necessary ventilation in the back of the kitchen furniture openings should be created in the dimensions shown in figure 2 The electrical connection must be in the area A in figure 2 or outside the installation site If the product is to be placed under a hob follow the dimensions given in the hob installation manual If the product will be placed in the tall cabinet Figure 3 In the back compartment of the kitchen furniture openings should be created in the dimensions shown in figure 3 in order to provide the necessary ventilation This opening should be along the height of the cabinet If there is a back panel of the tall cabinet where the product will be placed it must be removed The electrical connection must be in the A area in figure 3 or outside the installation area If the product will be placed to corner Figure 4a 4b Attention should be paid to the dimensions given in order to make the corner installation in the figure 4a and 4b Connecting the appliance to the electricity supply Only connect the product to a grounded outlet line with the voltage and protection as specified in the Technical specifications Have the grounding installation made by a qualified electrician while using the product with or without a transformer Our company shall not be liable for any problems arising due to the product not being earthed in accordance with the local regulations Before starting any work on the electrical installation disconnect the product from the mains supply There is the risk of electric shock The product must be connected to the mains supply only by an authorised and qualified person The product s warranty period starts only after correct installation Manufacturer shall not be held responsible for damages arising from procedures carried out by unauthorised persons The appliance must be installed so that it can be completely disconnected from the mains supply The separation must be provided by a switch built into the fixed electrical installation according to construction regulations Rear surface of the oven gets hot when it is in use Make sure that the electrical connection does not come into contact with the rear surface otherwise connections can get damaged