Zelmer ZCK1274E ECRU [9/52] Instructions for use

too full, the water will boil over!

Do not put the jug on a stove or in a microwave for re-heating of water.

Always place the kettle on a stable, smooth, flat surface; the power cord must not hang loosely off the

edge of a table (or any other work surface) or touch a heated surface.

Do not use the kettle with the lid open.

Do not remove the lid when the water is boiling.

If the internal electrical elements are flooded with water, make sure the kettle is completely dry before

plugging in.

Do not move while the kettle is switched on.

Unplug the product immediately from the mains in the event of any breakdown or damage and contact

an official technical support service. In order to prevent any risk of danger, do not open the device. Only

qualified technical personnel from the brand´s Official technical support service may carry out repairs or

procedures on the device.

Eurogama Sp. z o.o. disclaims all liability for damages that may occur to people, animals or objects, for

the non-observance of these warnings.

INSTRUCTIONS FOR USE

Before use

Make sure that all the product’s packaging has been removed.

Before heating water for the first time, we recommend using the kettle twice, in order to clean the

system.

Boiling water

Fill the kettle with fresh water through the open lid (press lid release button)

Read the quantity on the water level indicator. Do not fill less than the minimum and maximum marks

indicated.

Close the lid until it locks and place the kettle on the base.

Press the switch down, the switch turns on. If the kettle has led light, it will turn on. The water is heated.

The kettle switches off automatically once the water is boiled.

The appliance can also be switched off at any time by pulling up the ON/OFF switch.

Warning: If you remove the kettle from the base and replace it before the heating process is over, the

kettle will continue to heat the water.

Only operate the kettle with the lid closed and the limescale filter inserted.

After boiling, let the kettle cool down for 5 minutes before refilling it with water.

Do not turn on the appliance if the kettle is empty, otherwise the overheat control will engage and the

appliance will switch itself off automatically.

MANITENANCE AND CLEANING

1. Do not forget to remove the plug from the socket before cleaning the appliance.

2. Wipe outside with soft dry cloth when the kettle is wet, never use metal polish.

3. Remove the limescale filter soak it in a little vinegar, then rinse clean with clear water

4. Never use a dishwasher to clean any parts from the machine.

5. Rinse the kettle and the limescale filter with clear water

6. Put the water kettle in a dry and not very hot place.