AENO AP3 (AAP0003) [10/96] Maintenance

AENO AP3 (AAP0003) [10/96] Maintenance
10 aeno.com/documents
SLEEP , SPEED MID and SPEED HIGH buttons used to switch the fan
speed of the purifier in the following way: Sleep quiet mode, Speed Mid
medium rotation speed of the fan, Speed High – high rotation speed of the fan;
FILTER button that is blinking every time the filter shall be replaced (an
audible signal will also be emitted. You may stop it by pressing this button
again);
UV-C button used to turn on the UV lamp intended for air disinfection.
Maintenance
The HEPA filter shall be cleaned on a regular basis, but never rinsed up with
water or used after the end of service life. Please dry the HEPA filter regularly in
the sun. Do not remove dust from the HEPA filter with a vacuum cleaner or a
water jet.
The HEPA filter shall be replaced every 2,200 hours of operation (i.e. every 3-6
months). To remove dust from the HEPA filter, you shall remove it from the
purifier casing. Use a soft cloth with a neutral (non-aggresive) detergent to
remove dust or large pieces of dirt from the surface of the HEPA filter. The HEPA
filter shall be installed back in the purifier casing only after it gets dried. If the
device is not planned to be used for a long time, please store it covered with a
dustproof bag in a dry, cool and well-ventilated area. It is also recommended to
power on the device from time to time for at least a few minutes in order to keep
it in a good working condition.
ATTENTION! Do not allow water to enter the purifier.

Содержание

Скачать