AENO AP4 (AAP0004) Инструкция по эксплуатации онлайн [11/96] 648437

circuit breaker is on, and that the fuses are intact, and that the filter change

LED is blinking red.

2. The device makes a loud noise. Make sure that nothing is stuck in the fan,

and that the purifier is not tilted. If the noise is still too loud, try to reduce the

fan speed using the Speed Mid or the Sleep button. Also, use Sleep Mode to

operate the purifier at night.

3. Unpleasant odor coming from the purifier. If the device emits a plastic smell

during the first few hours of operation, this is deemed to be normal. However,

the device may also emit an unpleasant odor when the filter is clogged. In this

case, the filter must be cleaned or replaced. If you smell burning, unplug the

purifier immediately. Then, contact our Support Dept or the Seller of the device

for assistance.

4. The filter change LED is blinking after the filter was replaced or cleaned. Click

on the Filter button to restart the filter replacement timer, and the LED

indicator will be turned off.

ATTENTION! If your problem persists, please contact your local supplier or the

service center for support. Please do not disassemble the device or try to repair

it on your own.

Recycling information

These symbols indicate that you must follow the Waste

Electrical and Electronic Equipment (WEEE) and Waste

Battery and Battery Regulations when disposing of the device,

its batteries and accumulators, and its electrical and electronic

accessories. According to the rules, this equipment must be

disposed of separately at the end of its service life.