Delonghi PIND-30 [20/24] Fastening the cooktop

FASTENING THE COOKTOP

Each cooktop is supplied with a set of tabs and screws to fasten it on units with a work-

ing surface from 3 to 4 cm deep.

The kit includes 4 tabs A and 4 self-threading screws B (fig. 4.4).

• Cut the unit.

• Turn the hob upside down and rest the glass side on a cloth.

• Spread the seal C around the edge of the hob (fig. 4.5).

• Put tabs A into the mountings; only tighten screws B a few turns.

Make sure that the tabs are mounted correctly as shown in the figure 4.4.

• Put the cooktop into the hole cut into the unit and position it correctly.

• Put tabs A into place, tooth D of the tabs should go into the hole.

• Tighten screws B until the cooktop is completely secured.

• Using a sharp tool cut off the part of gasket C which protrudes from the cooktop. Take

care not to damage the workbench.

Adhesive side

Fig. 4.5

30 mm min.

40 mm max.

Fig. 4.4