Vitek VT-8283 [6/44] English

ENGLISH

• Before plugging the unit in make sure that the operat-

ing voltage of the unit corresponds to the voltage of

your mains.

• The unit is intended for operation from an AC power

network with the frequency of 50 or 60 Hz. The unit

does not need any additional settings for operating

with the required rated frequency.

HAIR STRAIGHTENING

• The unit can be used for both long and short hair.

• Use the unit only on healthy undyed and not permed

hair or use it along with special hair straightening

products.

• If your hair has been dyed or permed, use the unit

rarely.

• For the best results the hair should be clean and dry.

• Open the hair straightener moving clamp (5).

• Put the unit on a ﬂat steady and heat-resistant surface.

• Insert the plug into the socket, switch the unit on by

setting the power switch (3) to the position «On», the

power indicator (2) will light up.

Note: During the ﬁrst operation some smell from the heat

ing element is possible, this is normal.

• Let the unit heat up.

• Divide combed hair into locks of equal width (about

5 cm).

• Place the hair lock between the plates (1).

• Hold the unit by its handle (4) and press the plates (1)

together.

• Slide the heating plates (1) with little force to the hair

tips.

IMPORTANT: do not keep the plates on the same area of

the hair lock for more than 2 seconds.

• After that start straightening the next hair lock.

• Cool your hair down before ﬁnal styling or applying

hair spray.

• Avoid contact of heated surfaces with your face, neck

and other parts of your body.

• After use set the power switch (3) to the position

«Oﬀ», the indicator (2) will go out; then take the power

plug out of the socket. Let the unit cool down.

IM VT-8283_70x130.indd 6 09.04.2019 12:41:03