Denzel CS-210 [10/28] Circular saws

CIRCULAR SAWS

At the end of the work

•

disconnect the tool from the power supply, making sure the switch is in the o position;

•

clean the machine and its accessories from dust;

•

carefully fold the power cord to prevent damage to the cutting edges of the saw blade.

Recommendations for use

Use blanks of dry clean wood, free of nails, screws and other metal objects. Before you start processing the workpiece,

you must x it, especially if it is lightweight. Never hold the workpiece with your hand – unintended touch of a rotating

knife drum instantly causes serious injury.

Move the saw forward evenly, providing feed, at which the engine speed will fall. Thus, the highest of quality

processing is achieved and machine overload is prevented.

Do not overheat the exterior of the machine during prolonged use. In case of excessive heating, stop working, let the

machine work without load for 1 ... 2 minutes to cool the engine, turn o the engine and take a break till the case

is cooled.

Do not allow the machine to work when there is unwanted or unusual noise in the engine or mechanism. If noise

appears, turn o the machine and contact an authorized service.

Do not operate the machine when visible ashes appear in the engine ventilation openings, stop working and contact

the service center for diagnostics and, possibly, replacement of carbon brushes. Use saw blades with the number

of teeth and type of sharpening designed to handle the appropriate type of material. Consider that more teeth

increase the purity of the cut and reduce the permissible feed rate. Sharpening tooth shape with a negative rake angle

allows to reduce the number of chips on the treated surface (for example, when processing laminated blanks).

NOISE AND VIBRATION

Noise and vibration characteristics are given in the table №1.

However, if the circular saw will be used for other work with the use of working tools, not provided by the manufac-

turer, or maintenance will not meet the requirements, then the vibration level may be dierent.

ATTENTION!

Always use personal hearing protection.

MAINTENANCE

ATTENTION!

Before starting maintenance and adjustment of the tool unplug the power cord from the power

outlet.

If you have noticed a decrease in the speed of equipment or extraneous noise when working, it is necessary

to hand over the plane to the service center for its repair.

Working tool maintenance

The use of the worn working tool (discs) reduces the eectiveness of the work and may result in motor failure, it is there-

fore necessary to periodically replace worn out tooling as soon as this becomes necessary. Reducing the sharpness

of the cutting elements of the disk, their partial destruction or breakage are clear signs that it is time to change the disk;