Oregon 609457 CS300 без акк. и з.у [21/692] Assembling the guide bar and saw chain

Chainsaw Model CS300

Unpacking and Assembly

Assembling the Guide Bar and Saw

Chain

WARNING: A battery operated tool with

the battery pack inserted is always on and

can start accidentally. Remove the battery

pack from the chainsaw before attaching

the bar and chain.

Wear gloves.

• Remove the battery.

• Loosen the side cover release knob by turning

it counter clockwise, then remove the side

cover.

• There is a rubber o-ring that is important to

the function of the saw. The rubber o-ring

must be in place around the pin on the

tensioner before the tensioner is screwed onto

the bar (Fig. ).

• Insert the screw from the back side of the

chain tensioning gear and attach the chain

tensioning gear onto the guide bar (Fig. ).

• Place the chain tensioning gear on the side

of the guide bar facing you such that the

rectangular piece does not protrude past the

edges of the guide bar and insert the screw.

• Place the guide bar on the bar pad by sliding

the bar slot over the alignment flange (Fig. ),

with the mounting stud inserted through the

hole in the chain tensioning gear.

• Loop the new saw chain onto the drive

sprocket so that the cutting edges of the

teeth along the top of the bar face away from

the powerhead (Fig. ).

FIG. 10

FIG. 11

FIG. 12

BAR PAD

ALIGNMENT FLANGE

MOUNTING STUD

FIG. 13