Denzel AG125-1100 [3/32] Angle grinder

ANGLE GRINDER

PROPER USAGE AND GENERAL INFORMATION

Angle grinder (hereinafter «machine», «tool») is designed to perform cutting, grinding, stripping operations with

metal structures or blanks using special abrasive discs and brushes. Subject to certain conditions an application

for processing of a stone, concrete, a brick is possible.

The tool is designed for usage at an environment temperature from 0 °С to 40 °С, relative humidity not more than

80% and absence of direct exposure of atmospheric condensation and excessive air dustiness.

The machine is suitable only for private use and must be used in intermittent duty not more than 20 hours per

month. It is recommended to use on-loading not more than a nominal, during 10-15 minutes and then to have a

break for 20-30 minutes. This usage mode enables to complete domestic tasks eectively and prevents the tool

from a premature coming out of order.

This manual contains the information and the requirements necessary and sucient for a sure, eective and

secure use of the tool.

Due to ongoing activities in order to improve the tool the manufacture reserves the right to make minor changes

in its construction, not mentioned in this manual and not worsening its consumer and operational properties,

eective and secure use.

ACCESSORIES

Contents of delivery:

1. Angle grinder 1

2. Side handle 1

3. Special key 1

4. Set of spare carbon brushes 1

5. Instruction manual 1

6. Warranty card 1

SPECIFICATIONS

Table 1

Parameter

Value

AG-115-750 AG-125-1100

Maximum disc diameter, mm 115 125

No load speed, min

-1

12000 3000-12000

Rated input power, W 750 1100

Voltage, V 230 230

Frequency, Hz 50 50

Electronical speed control No Yes

Spindle thread М14 М14

Constant speed control No Yes

Soft start No No

Protection against accidental switch on Yes Yes

Lock on switch Yes Yes