Clage DSX Touch (039535) [21/29] Statistics

CLAGE

Statistics

The statistics save the consumption and usage data for the appliance and display them

in graph format:

Water consumption

Power consumption

Total consumption costs

Tap on or

to scroll through the different periods. The consumptions are displayed

consecutively in diagrams over a period from the last drawing of water, the consump-

tion today, the consumption yesterday, over the last seven days, the last four weeks,

the last twelve months and the last four years.

The last overview shows, if the savings target is activated, when your savings target

was reached or exceeded in the last twelve months. Furthermore, it calculates how

much your energy and water consumption has stayed below the savings target, and

displays the figure.

Note: The consumption data are not suitable for billing purposes.

Quantity: Under “Quantity” tap on or to set the desired water quantity and then tap

on “START” to activate Automatic mode. The view changes to the main control where

the set quantity is displayed directly below the temperature display. Turning on the hot

water tap starts the function and the set fill quantity counts down in litre increments

according to the flow measurement.

Continued turning off and on of the tap pauses and restarts the function. If hot water is

already flowing whilst the function is activated, it starts immediately. To cancel the func-

tion, touch the fill quantity for three seconds or turn off the water flow for a minute.

When the fill quantity is reached, “0 l” flashes briefly on the display. A long acoustic

signal can also be heard and an instruction message appears on the display. The flow

quantity is reduced to approx. 3 l/min until the hot water flow is stopped or the message

is confirmed. This method ensures that any heated water continues to run and the bath

does not cool down. Flow noises can occur during the flow reduction.

Turning off the tap is always necessary, the function must therefore not be used unsuper-

vised.

Before using the bath, make sure that the water temperature is what you want it to be.

Hint: The water amount of the last draw-off is stored in the “Statistics” menu. To deter-

mine the necessary amount of water for your bathtub, fill it with warm water, then select

“Statistics” in the main menu and read out the value of this last drawing. Enter this value

in the automatic function “Quantity” to use it for the next bathtub filling.

Note: In the event of a power cut whilst the automatic is running according to the

fill quantity, the water flow is reduced to a minimum after the power has been

restored, a prompt appears on the display and an alarm signal can be heard until

the prompt is acknowledged by tapping on “OK”.

3. How to use

www.clage-com.ru