Bosch EasyGrassCut 26 (06008C1J00) [21/309] Assembly

Bosch EasyGrassCut 26 (06008C1J00) [21/309] Assembly
English | 21
Assembly
u Caution: Switch the garden tool off and pull the mains
plug before performing any maintenance.
Connect shaft (see figures C and D)
Note: A connected shaft can no longer be dismounted.
Remove the transport safety (7).
Connect the individual parts of the shaft until they can be
heard to engage.
Mounting and adjusting the handle (see figure E)
The handle (1) can be set to different positions. To change
the adjustment, press buttons (5) and move the handle to
the desired position. Release the buttons (5) again so that
the handle can engage.
Mounting the protection guard (see figure F)
Position the protection guard (6) on the trimmer head and
fasten it with the provided screw.
Operation
u Pay attention to the mains voltage. The voltage of the
power source must match the voltage specified on the
rating plate of the machine.
u Caution: Switch the garden tool off and pull the mains
plug before adjusting or cleaning.
u The cutting line continues to rotate for a few seconds
after the trimmer is switched off. Allow the motor/cut-
ting line to stop rotating before switching on again.
u Do not briefly switch off and on again several times in
a row.
u Only use Bosch approved cutting elements. Cutting
performance will vary with different cutting elements.
Switching On and Off (see figure G)
To switch on, firstly press the lock-off button (2). Then
press the On/Off switch (3) and keep it pressed.
To switch off, release the On/Off switch (3).
Dismounting the spool, winding up the cutting
line and mounting the spool (see figures J to H)
u Remove the mains plug before replacing the spool.
Press both latches of the spool cover together and remove
the spool cover (9). Afterwards, remove the empty spool
(10).
Cut off approx. 4.0 m line from the refill roll. Slide one end of
the cutting line into the hole for line wind-up (11) in the
spool and wind up the cutting line uniformly and tightly.
Slide the other end of the cutting line through the hole for
line guiding (12) in the trimmer head and mount the spool
back into the trimmer head. Affix the spool by mounting the
spool cover .
Line Feeding (see figure K)
Semi-automatic Line Feeding
The trimmer is equipped with a semi-automatic feeding sys-
tem. The system feeds 10mm of the line with every press of
the on/off switch (3).
Manual Line Feeding
Press the line-feed button (13), and pull the cutting line out
to the desired length.
Troubleshooting
Problem Possible Cause Corrective Action
Motor refuses to start Power turned off Turn power on
Mains socket faulty Use another socket
Extension cable damaged Inspect cable, replace if damaged
Fuse faulty / blown Replace fuse
Garden tool functions
intermittently
Extension cable damaged Inspect cable, replace if damaged
Internal wiring of garden tool defective Contact Bosch customer service agent
Garden product la-
bours
Grass too high Cut in stages
Garden tool does not
cut
Cutting line too short/broken off Manually feed cutting line
Spool empty Replace line spool
Cutting line can no
longer be fed
Line inside the spool entangled Inspect the spool, rewind if necessary
Spool empty Refill line spool
Bosch Power Tools F 016 L81 799 | (24.10.2018)

Содержание

Похожие устройства

Скачать
Случайные обсуждения

Ответы 0

как заменить катушку?
1 год назад

Ответы 1

Как заменит леску
2 недели назад