Sinbo SK-7321 [9/44] How to use
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Sinbo SK-7321 [9/44] How to use

Sinbo SK-7321 [9/44] How to use
- 8 -
HOW TO USE
Positioning
* Position the power base as close to a wall socket as possible.
* Route the mains lead so that it dose not overhang the work surface, and cannot be caught accidentally.
Shorten the mains lead by winding it round the cord storage area under the power base, and bring it
out of the cord exit cut into the base.
Opening the lid
Remove the kettle from the power base (9).If the switch (7)has been pushed down inadvertently, it will
spring up, into the OFF position.
Warning: If the kettle has just boiled, it will be full of steam, which will escape as soon as the lid is
opened.
Hold the handle firmly in one hand, grip the lid knob in the other, and pull the lid straight up. As soon
as it separates from the kettle, move it out of the steam.
Filling
* Open the lid and fill the kettle via the lid aperture.
* Watch the level in the water level indicator. You must use at least one cup of water, but the water
level must be below the max mark.
* Do not overfill the kettle. If the kettle is overfilled, there is a risk that boiling water may be ejected.
* Replace the lid and press it down. Check that it is fully closed; otherwise the kettle may not switch
off when it boils.
Switching on
* Check that the switch is in the “OFF” position (lifts the kettle from the power base and set it down
again).
* Plug the power base into the wall socket. If necessary, switch the socket on. Gently position the kettle
on the power base, taking care not to spill any water.
* Press the switch down. The switch will light up, and the kettle will start to heat up.
* When the water has boiled the kettle will switch off automatically, the switch will return to the “OFF”
position and the light will go out.
Switching off
* If you need to switch the kettle off at any time before the water boils, simply lift it front the power
base and set it down again. The switch will pop up, into the “OFF” position
GENERAL
* When you lift the kettle from the base, you may see moisture on the surface of the base. This is the
steam used to switch the kettle off automatically, which then condenses and is allowed to escape via
vents in the underside of the kettle, do not lift it backwards, as this may allow water to pass through
the steam aperture on to the control area. Should this occur, the kettle must be allowed to dry before
use.
* To avoid the risk of splashing, pour slowly and do not over-tilt the kettle.
MISUSE
1. Do not switch the kettle on unless it contains at least one cup of water. Misuse of this kind will shorten
the life of the element.
2. If the kettle is accidentally switched on when it does not contain sufficient water, a boil-dry device
will automatically switch it off. Wait until the kettle has cooled down before filling, as the element will
be hot and spitting may occur

Содержание

Похожие устройства

Скачать