Sinbo SFH-3323 [9/16] Wall assembly

- 8 -

WALL ASSEMBLY

1. The heater shall be mounted on a sturdy surface like concrete, stone or metal. Do not

mount the unit on flammable surfaces.

2. “L” brackets shown in the figure shall be fixed to the nuts inside the rail behind the

heater housing using M5 YSB bolts, centering the heater with a 50 mm distance between

them.

3. The other 2 “L” brackets shall be fixed on the wall or to the ceiling parallel to the floor,

using 2 fixing plugs with the identical distance between them.

4. “L” brackets to be mounted on the and “L” brackets in the rear of the heater are fixed

to each othet using butterfly nuts upon adjusting the desired angle of the heater.

CLEANING AND MAINTENANCE

Clean your heater regularly.

* Unplug the unit before cleaning.

* Remove the safety grill using a flathead screwdriver without damaging the housing.

* Clean the reflector with a soft cotton cloth or a suitable brush.

* Do not use cleaning agents which may damage the reflector.

* Install the wire grill using a flathead screwdriver.

WHILE CARRYING

* Do not drop the unit,

* Avoid any impacts on the device,

* Ensure that it is not pinched or crushed,

* Observe the markings on the package.

CORRECT DISPOSAL OF THIS PRODUCT

This marking indicates that this product should not be disposed with other

household wastes throughout the EU. To prevent possible harm to the

environment or human health from uncontrolled waste disposal, recycle it

responsibly to promote the sustainable reuse of material resources. To return your used

device, please use the return and collection systems or contact the retailer where the

product was purchased. They can take this product for environmental safe recycling.