HYUNDAI ELECTRONICS H-CCR2701G [4/31] Before you start
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

HYUNDAI ELECTRONICS H-CCR2701G [4/31] Before you start

HYUNDAI ELECTRONICS H-CCR2701G [4/31] Before you start
4
Before you start
Installation
General notes
• Choose the mounting location where the
unit will not interfere with the normal driving
function of the driver.
• Before finally installing the unit, connect
the wiring and make sure that the unit works
properly.
• Consult with your nearest dealer if
installation requires the drilling of holes or other
modifications of the vehicle.
• Install the unit where it does not get in the
driver’s way and cannot injure the passenger if
there is a sudden stop, like an emergency stop.
• If installation angle exceeds 35° from
horizontal, the unit may not perform properly.
• Avoid installing the unit where it would
be subject to high temperature, such as from
direct sunlight, or from hot air, from the heater,
or where it would be subject to dust, dirt or
excessive vibration.
Mounting
• Connect the cable set and the antenna to
the vehicle’s electronics corresponding to the
connection table (see farther).
• Attach the mounting racks to the sides
and to the back of the unit, and fix them with
the screws.
• Insert the unit into the slot until the stop.
The unit then audibly snaps.
• Fasten the screws to fix the unit.
• The device is distinguished by a high
degree of output. During operation, this results
in a strong heat generation. Therefore no
cables or other parts may adjoin the device. If
their insulation melts, there is the risk of a short
circuit or fire.
• Removing: Turn off the device. Clamp off
the negative pole of the vehicle battery for the
duration of the disassembly. Unscrew the four
screws. Remove carefully the unit from the slot
and disconnect all wires. Make sure that no
vehicle cable can cause a short circuit after the
device has been unplugged.

Содержание

Похожие устройства

Скачать