Timberk THU UL 11 [7/28] Important

www.timberk.com • electric humidifier

9. CLEANING AND MAINTENANCE

Prior to cleaning the unit make sure the power supply’s plug is disconnected

from the outlet. Otherwise, it may cause electric shock.

Prior to cleaning wait until water, remaining in the unit’s case, completely

cools down, to avoid getting burned.

Clean the unit once or twice a week.

9.1. Use a damp and soft fabric to wipe the unit’s external surface.

To avoid electric shock do not scratch or damage elements of the unit

when cleaning.

When cleaning, do not use solvents, benzene, xylene, scrub brush, talc

powder and other substances except for water.

9.2. Wipe off remains of water on the unit’s base using a damp and soft

fabric.

To wipe of remains of water on small parts you can use a soft brush and

then wipe them with a soft fabric again.

9.3. In case of dirt on the membrane, clean it with a brush.

9.4. Use a soft brush to wipe off remains of water on the surface of the

atomizer’s nozzle, then wipe it with a soft fabric again.

9.5 Wash the water tank and the atomizer by clean water. Wash the cap

with the valve carefully and lightly, otherwise it may cause water leaks

through the cover.

After removing water from the atomizer’s surface clean it with a soft fabric.

Clean the unit’s external surface with a damp and soft fabric.

9.6. Clean the air filter if:

- the air flow from the air outlet grill became weaker and the noise increased;

- the filter color has changed, which indicates that the filter is dirty.

IMPORTANT!

To avoid deformation or wear of working surfaces,

resulting in decreased atomizing or other malfunctions,

do not use metallic brushes, blades or talc powder to

wipe the surface of the atomizer’s nozzle.

The water tank may leak upon heavy impacts.

In case of water leakage, immediately stop using the unit

and contact a service center.

To keep the unit dry, remove water after cleaning and

make sure to dry the unit’s case.

Make sure that there is no water left inside the unit’s

case.

Prior to a long break in using the unit, dry its surface and

pack it into a plastic bag, then put it into a box.

Store the unit in a low-humidity room.

Storing the unit undried results in generation of mold.