Home
Главная
Elenberg
Пылесосы
VC2010
Руководство по эксплуатации Страница: 5

Elenberg VC2010 [5/6] Описание

Описание

1. Шнур питания

2. Кнопка включено/выключено

3. Регулятор мощности всасывания (опция)

4. Ручка для переноса

5. Кнопка сматывания шнура питания

6. Окно контроля заполнения пылевого мешка

7. Место подсоединения всасывающего шланга

8. Всасывающий шланг

9. Рукоятка открытия отсека пылевого мешка

10. Отсек пылевого мешка

11. Всасывающий шланг, 2-я часть

12. Насадка всасывающего шланга

13. Отсек принадлежностей

14. Крючок всасывающего шланга

15. Отверстие для крепления всасывающего шланга при хранении (не показано)

Принадлежности

1 Насадка для чистки обивки мебели

2 Насадка «2 в 1» (насадка для чистки щелей и щетка).

Air Slide:

Open the air slide on the handle of the hose to regulate the air supply or to clear off any

particles sticking to the nozzle.

Dust bag replacement display (6):

Hold the hose up into air. If the dust bag change display lights up, the bag is full. Please

change it.

Changing the dust bag:

Remove the mains plug from the socket. Then open the lid of the dust bag compart-

ment (10) by pressing the button (9). Remove the bag holder, press the button with the

spring together in order to release the bag and then pull the dust bag out of holder.

Press the button again and fix a new bag in place. Re-insert the bag holder and then

dose the lid so that its locks in place.

Filter:

Your appliance has two filters.

Motor pr

otection filter (inlet filter):

The inlet filter is located in the dust bag compartment. The filter is located vertically in

the rear section of the dust housing. . Remove the filter by pulling upwards. Clean the

engine protection filter after l Just bag changes. If necessary, the filter can also be

washed in warm water out anany additives. Place it back into place only once it is com-

pletely dry!

Outlet filter:

The appliance is also equipped with an outlet filter. It is located on the rear part of your

appliance behind a ventilation grid. Open the ventilation grille by pressing the button

above it. Then pull the grille out towards the front. Remove the filter and dean as

described above. Fit the filter back into place and close the ventilation grid by following

the steps above in the opposite order.

CLEANING AND STORAGE

Cleaning

• Pull the plug out of the socket before cleaning!

• Clean the casing with a dry cloth.

Storage

• Let the iron cool down completely.

• Wind the cable completely.

• Please place the machine in a vertical position and insert the hook (14) on the suction

tube into the parking assistance (15) on the back.

This device has been tested according to all relevant current CE guidelines, such as

electromagnetic compatibility and low voltage directives, and has been constructed in

accordance with the latest safety regulations.

Subject to technical changes without prior notice!

Elenberg VC2010 [5/6] Описание

Содержание

Похожие устройства