Sencor SWS 51 B [4/9] Effective range of the external sensor

Похожие устройства

3 After the main unit receives all the data lnformation about the temperature in the installation location of the external sensor the main unt will start searching for the time standard signal transmitted by the DCF transmitter located in Germany Reception of the signal from the DCF transmitter is indicated on the display of the main unit by the appropriate icons The time standard signal is being received The j icon is flashing After sucessful reception The j icon is flashing Unsuccessful reception The icon is not display Additional information Pressing DOWN CF button on the device in the operating mode will display information about the reception mode and signal strength from the DCF transmitter on the display of the main unit The signal strength of the DCF transmitter is indicated on the display by one weak to three bars strongest during standard use of the device thre are two top three bars signal strength fluctuates shown on the display Automatic and manual reception of the time standard Time of automatic RCC signal receiving 2 00 a m 3 00 a m 4 00 a m and 5 00 a m If the reception is successful it will not enter the receiving again that day RCC receiving time is 7 minutes To start manual reception of the stardard hold DOWN CF button Press the button again to end the reception of the stardard During the time when the time standard signal is being received by the device other buttons on the main unit are disabled The value of the measured outdoor temperature will stabilise after approx 30 minutes of the operation of the external sensor Effective range of the external sensor The maximum effective range of the outdoor sensor is up to approx 30 meters and is affected by obstacles found in the area between the sensor and the main unit in particular walls ceillings doors windows etc Installation location of the sensor The cover of the external sensor is not waterproof If the sensor is located outdoors then it must be located in a covered area so that it is not directly rained or snowed on Never place the sensor on metal surfaces or objects or place inside metal covers If possible locate the sensor on the northern side of the house so that the temperature reading is not skewed by the effect of sunlight SETTING THE CLOCK 1 Hold SET key for 2 seconds to enter into time setting 2 The sequence of time setting Time Zone Hour Minute Year Month Date Language 3 There will have 1 Hz flashing during setting 4 Press SET to confirm the setting and enter the next setting state EN 3