Elenberg EGP 4100 [7/8] Electrical connections

INSTALLATION

Installing the Gas Hose

· This appliance is adjusted to work with Natural Gas.

· Heat the gas hose and push into the inlet.

· Later heat the cuff and x on the hose.

Electrical Connections

· Ensure that the electrical supply complies with the Type stated on

the rating plate

· The appliance is adjusted to 220-230 V, 50-60 Hz. The fuse of the

socket must be 16 A or more. If the voltage in your neighborhood

is 110 V, consult a qualied electrician.

This Appliance Must Be Earthed.

USING THE APPLIANCE

Using of Gas Burners

Knobs located on the control panel control the

gas burners. To light one of the burners, hold a

lighted match or lighter near the burner. Press

down and turn the corresponding knob in the

counter-clockwise direction to the desired setting

maximum or minimum. To turn off the burner, turn

the knob clockwise to the “●” setting.

Electronic Lighting Of The Hob Burners

Some models are equipped with instant electronic ignition device.

This device is activated by pressing on the ignition button, identied

by symbol “ ”. To light a burner, simply press the ignition button

and then press a while, at the same time, pressing in and turning the

control knob for the burner in the counter-clockwise direction until

the burner lights.

Caution: If the burner accidentally extinguishes, turn off the burner

using the knob and wait at least one minute before relighting.

Using of Hot Plates

Knobs located on the control panel control the

hot plates. To use one of the hot plates, turn the

corresponding knob in the counter-clockwise di-

rection to the desired setting: “1” low heat cook-

ing; “2” heating; “3” cooking, frying, boiling. To

turn off the hot plate, turn the knob clockwise to

the “●” setting.