Philips QC5099 [8/106] English



Corded clipping

Do not run the appliance from the mains when the battery is fully

charged.

To use the hair clipper connected to the mains: switch the hair clipper off,

connect it to the mains and wait a few seconds before switching it on.



Select the small or large comb attachment, depending on the desired hair

length.



The hair length settings are indicated in millimetres on the arms of

the comb attachment. The settings correspond to the remaining hair

length after cutting (Fig. 3).

The small comb cuts hair to a length of 3mm, 6mm, 9mm, 12mm,

15mm, 18mm or 21mm.

The large comb cuts the hair to a length of 23mm, 26mm, 29mm,

32mm, 35mm, 38mm or 41mm.

1 Slide the arms of the comb attachment into the guiding grooves of

the appliance (‘click’) (Fig. 4).

Make sure that the arms of the comb attachment have been properly slid

into the grooves on both sides.

2 Set the comb to the desired hair length by turning the hair length

adjustment ring to the right or to the left (Fig. 5).

3 Switch on the appliance.



We advise you to start clipping at the highest setting of the large

comb and to reduce the hair length in small steps until you reach the

desired hair length.

If a lot of hair has accumulated in the comb, remove the comb

attachment and blow and/or shake the hair from the comb. Removing

the comb does not change the selected hair length setting.

ENGLISH8