Homedics TBS-2010H-GB [6/64] Instructions for use

Homedics CBS-2000H-EU [6/64] Instructions for use
6
GB
7
INSTRUCTIONS FOR USE:
IMPORTANT - Preparing the appliance for use
The massager comes with a screw located on the back of the unit to protect the massage mechanism during
shipment, which must be removed before the first use to allow the shiatsu feature to function. Use the
provided Allen key. Then, properly dispose of the screw.
WARNING – Failure to remove screw may cause permanent damage to the appliance.
Error: all remote control LEDS flash for a few seconds.
Cause: massager overloaded.
Solution: ensure the allen key bolt/screw has been removed from back of the massage cushion (using the
allen key included). Should the condition continue after this please contact your HoMedics service centre.
Strapping System
The massager incorporates a unique strapping system which allows you to fasten it to almost any chair. Just
slip the straps over the seat or chair and adjust fastening straps to secure. Your massager won’t slip or slide
away.
Note: Do not use this product for more than 20 mins at a time.
NOTE: complete steps 1 and 2 before switching the appliance on at the mains.
1. Attach the Massage seat to almost any chair using the integrated strap located at the back of the seat.
Ensure it is held firmly in place by adjusting the strap as necessary.
2. Connect the power supply lead into a 220-240V AC mains outlet and switch on.
3. Once seated, use the remote control to operate the appliance. Press the button.
Demo mode
– Press demo button
– Up/Down
rs
arrows will flash for shoulders
– Press down
s
arrow to lower the shoulder mechanism on to
your shoulders (the nodes will partially inflate before the
mechanism starts to move, hold until the nodes reach your
shoulders then release the button – the nodes will then
deflate before massage starts)
– Demo mode will then cycle all massage modes
Air Shoulder massage mode
– Use Up/Down arrows
rs
– Press down arrow
s
to lower the shoulder mechanism on to your shoulders (the nodes will partially
inflate before the mechanism starts to move, hold until the nodes reach your shoulders then release the
button – the nodes will then deflate)
– Press the shoulder massage button to activate Thai air compression massage – intensity can be set
using the +/- button
(Note: intensity for both shoulder and lumbar are controlled simultaneously)
Heat is controlled simultaneously on gel shiatsu back massage and Thai air compression shoulder
massage
4. Select lumbar air massage and/or shiatsu gel massage // as required.
5. Press the button to stop the massage.
Before use lift the Thai air compression
shoulder massage mechanism so you can
rest your head comfortably.
WEEE explanation
This marking indicates that this product should not be disposed with other household wastes
throughout the EU. To prevent possible harm to the environment or human health from uncontrolled
waste disposal, recycle it responsibly to promote the sustainable reuse of material resources. To return
your used device, please use the return and collection systems or contact the retailer where the
product was purchased. They can take this product for environmental safe recycling
IB-CBS2000H-0512-01_Layout 1 12/06/2012 15:42 Page 6

Содержание

Скачать