Lexicon PCM96 — управление резонансом и реверберацией в музыкальных алгоритмах [49/68]
Превью страниц
Страница 49 /
68
![Lexicon PCM96 Руководство по эксплуатации онлайн [49/68] 758093](/views2/1989808/page49/bg31.png)
43
Resonance Master
Controls all voices in the algorithm. Each voice has its nominal resonance
adjusted by this percentage.
Resonance Tuning Master
Affects all voices in the algorithm. Each voice has its nominal resonance
adjusted by this value. In the musical world, the tuning reference is A=440.
This means that the note A (above middle C) is equivalent to 440 Hz.
Changing the master tuning causes all notes to be sharp or flat.
Resonator Detune
This parameter acts as an adjustment to the specified frequency for the
voice’s resonator. The calculation of cents yields a ratio which is used to
modify the specified frequency of the voice. This parameter is modified by
the Master Detune parameter.
Resonator Filter Freq
This parameter controls a lowpass filter inside the resonator.
Resonator Frequency
This parameter determines at which frequency the delay voice resonates. The
action of this parameter is determined by the state of the Resonance Mode
parameter. When a frequency is calculated for this parameter, it must then
be affected by the value of the Master Tuning parameter.
Reverb PreDelay (Predelay)
This is a delay that’s added to the diffused signal before it enters the main
part of the reverb. For all intents, it may be considered as delay that is added
to the reverberated signal. It is used to temporally separate the reverb from
the dry signal.
Reverb Spin (Spin)
This is usually simply called spin. It controls the speed of the reverb random-
izer. Spin is also connected with the Reverb Wander parameter
Reverb Time Hi Cut
This parameter, also known as Hicut or RTHC is a low-pass filter in the
recirculating part of the reverb. It represents a frequency above which the tail
dies away more quickly. In some ways, it represents the opposite end of the
scale from BassRT, and may be considered an analog of air absorption. It is
also closely tied to the Hi Cut Damping parameter.
Reverb wander
This parameter (also known as just Wander), along with Reverb Spin, is used
to control the reverb randomizer. It controls the maximum size of random-
izer steps, and is expressed in a time value (typically milliseconds).
Room Size
Room Size corresponds roughly to the length of the longest wall of a rect-
angular room. In a more general sense, it corresponds to the overall dimen-
sion of some mythical space. This space has a geometry that causes sound
Содержание
58- Safety instructions
- Warning for your protection please read the following
- Important safety instructions
- Important safety instructions
- Declaration of conformity
- Warranty
- Introduction
- The front panel
- 8 7 6 5 4 3
- The rear panel
- Single stereo config
- Predelay 20ms 2 reverbtime 2 9s 3 rvboutfreq 6500 hz
- Large hall
- Current preset clock sync icon
- Current preset
- Configuration icon soft row parameters
- Configuration icon
- Clock sync icon
- System view
- System menu version 1 audio setup system control midi control
- Single stereo config
- Flange
- Audio source analog a clock source internal b clock rate 48khz lock c
- Audio setup
- Default configurations combined mono reverbs combined mono effects
- System category selection
- Preset category selection
- Halls small halls medium halls large
- System view
- Flange
- Configuration icon system preset
- Soft row parameters
- Predelay 14ms 2 reverbtime 1 9s 3 rvboutfreq 4750 hz
- Predelay 14ms 2 midrt 1 9s 3 rvboutfreq 4750 hz
- Med hall
- Configuration icon machine preset
- User card
- Save as single stereo config
- Empty 1 empty 2 empty 3 empty 4 empty
- Change position
- Change letter
- Dsp configurations
- The pcm96 plug in
- Networking
- System menu
- Using midi
- Machine menu
- The algorithms
- The parameters
- Pcm 96 menu navigation map stereo hall algorithms
- Pcm 96 menu navigation map stereo delay algorithms
- Pcm 96 menu navigation map stereo effects algorithms
- Pcm 96 menu navigation map mono hall algorithms
- Pcm 96 menu navigation map mono chamber and room algorithms
- Pcm 96 menu navigation map mono delay algorithms
- Pcm 96 menu navigation map mono effects algorithms
- Pcm96 specifications
- Midi implementation chart
Похожие устройства
-
AUDIENT EVO 4Руководство по настройке -
AUDIENT iD4 mkIIРуководство по эксплуатации -
Maono E2 Gen2Инструкция пользователя -
Madboy REMIX-31Инструкция по применению -
AUDIENT iD14Руководство по настройке -
JBL CHARGE 5Руководство по работе с устройством -
EUROSOUND Crisp-16XРуководство по использованию -
ALLEN & HEATH XONE:K2Руководство по работе с устройством -
Novation LAUNCHKEY 61Руководство по настройке -
SUPERLUX E431UРуководство по настройке -
APart MICPAT-4Инструкция по работе -
Mooer STEEP IIРуководство пользователя
Изучите параметры управления резонансом и реверберацией в музыкальных алгоритмах. Узнайте, как они влияют на звук и создают уникальные аудиоэффекты.