ASHLY PE-800 [11/13] Measurements

Operator Manual – PE Series Amplifiers Page - 11

Measurements

The following graphs are actual measurements from PE-Series amplifiers during typical use.

Gain vs. frequency, Ch1, Ch2 - (typical performance) Gain vs. frequency / positions of HPF, Ch1, Ch2

Phase vs. frequency, Ch1, Ch2 Phase vs. frequency / positions of HPF-Switch, Ch1, Ch2

Output impedance vs. frequency @ 1 Amp RMS injected current

(Ch1, Ch2) equivalent 11 m + 2,1 μH

THD+N @ 1 kHz, 8  load vs. input voltage, Ch1, Ch2

Damping factor into 8 , Ch1, Ch2 equation: damping factor =

loaded impedance / amplifier output impedance

THD+N vs. frequency (BW 22 kHz),

10 dB below clip, 8, Ch1, Ch2

CCIF difference frequency method (10,5 kHz and 11,5 kHz) vs. input

level @ 8 , Ch1, Ch2

SMPTE intermodulation distortion (60 Hz and 7 kHz)

@ 8  vs. input level, Ch1, Ch2

Common mode rejection ratio (Ch1, Ch2) Channel separation vs. frequency

@ 10 W / 8  (Ch1 => Ch2, Ch2 => Ch1)

Important Safety

Instructions – 2

Introduction - 3

The PE Series - 4

Physical Description - 5

Installation – 6

Operation – 8

Troubleshooting - 9

Spec Table - 10

Measurements - 11

Dimensions - 12

Warranty - 13