APart CHAMP-2 Руководство по эксплуатации онлайн [10/16] 759211

WWW.APART-AUDIO.COM

1)Channel2unbalancedinputoncinchconnectors:usethetoporbottomcinchconnectorto

applyanunbalancedsignalonchannel2.Theseconnectorsarewiredinparallel,thismeans

you can use the second connector as a signal link connector.

2)Channel2balancedinputonNeutrikXLRconnector,thisconnectoriswiredinparallelto

connector‘3’.Thisallowsyoutolinkthebalancedsignaltoanotheramplier.

3)Channel2balancedinputonNeutrikXLRconnector,thisconnectoriswiredinparallelto

connector‘2’.Thisallowsyoutolinkthebalancedsignaltoanotheramplier.

4)Groundliftswitch:usethisswitchtoliftorconnectaudiogroundtosafetyground.Thiscanbe

usefull in case of hum.

5)Speakerloadimpedanceselectorchannel2:setthisselectorcorrectlyaccordingtothe

actualloadimpedance.For4to8ohmsapplications:switchisnotpushedin.For2to3

ohmapplications:pushthebuttonin.Pleasenotethattheimpedancementionedisthetotal

loadoftheamplierchannel,thismeansthatifyouconnectforexample3speakerswith8

ohmimpedance,youMUSTpushthebuttoninbecausetheloadontheamplieris8:3=

2.7 ohms. In case of bridge operation this button has no function. Use channel 1 impedance

selector in case of bridge operation.

6)Channel2speakerbindingpost:thisconnector

acceptsspeakercableaswellas4mm

banana plugs. Remove the protective cover from the middle of the red/black binding post in

caseyouwanttousebananaplugs.Forbridgemodeapplications,youMUSTusethered

bindingpostsonly:channel2redplugisbridgemodenegativespeakerconnector.

7)Mainscableconnector:plugthemainscableconnectorhere,thissocketalsocontainsamains

fuseholder.Replacethisfuseonlywitha3AT250Vtype.

8)Channel1speakerbindingpost:thisconnectoracceptsspeakercableaswellas4mm

banana plugs. Remove the protective cover from the middle of the red/black binding post in

caseyouwanttousebananaplugs.Forbridgemodeapplications,youMUSTusethered

bindingpostsonly:channel1redplugisbridgemodepositivespeakerconnector.

Rearpanellayout:

1 2 3 4 5 6 7 8 9 10 11 12 13