Polaris PVCR 3200 Руководство по эксплуатации онлайн [87/175] 762181

87

way of shaking out, or by means of special brush. If necessary, rinse the HEPA-filter under a thin jet of water of a

room temperature. No detergents shall be used. (Fig. 19)

- Rinse the dust bag under fresh water. (Fig. 20)

- Dry out the filters and dust bag in the natural manner prior to installation.

No heating is allowed.

- Install the filters,

- Close the container and install it on its place.

The electric brush is intended for collection of household dust from the floor and carpets by means of a rotating

bristle roller. Its design is quite a susceptible to clogging with long hairs, wool, threads etc. In case of clogging,

you should immediately cease vacuum cleaner operation, and take measures for cleaning the bristle roller. The

cleaning should be performed each time after vacuuming.

The roller has got a separate electric drive which engages simultaneously with the vacuum cleaner motor.

To clean the roller: (Fig. 22)

1. Turn off the device through I/O switch (by setting it to "O" position).

2. Flip the vacuum cleaner so that its rear part faces toward you.

3. Given a small amount of hairs and threads having wound around the bristle roller, they can be cut away

with a knife without detaching the bristle roller. For this, position a sharp knife between rows of bristles so

it out of the socket. Having the bristle roller taken out of the body, use a knife or scissors to easily clean the

roller from any hairs and threads wound around it.

6. Installation of the bristle roller back to its place in the brush body shall be performed in the reverse manner.

7. Given a severe clogging of components of the brush and electric drive, contact an authorized service center

for disassembling and cleaning.

CLEANING THE LATERAL BRUSHES (Fig. 23)

1. Turn off the vacuum cleaner.

2. Check the brushes for any defects and / or foreign items, as well as debris having wound around.

3. If necessary, detach the brushes.

4. Wipe the brushes with a piece of cloth preliminary soaked in hot water and well wrung. Perform the

- Use a piece of dry soft cloth to wipe the contact leads at the vacuum cleaner bottom, or on the base (Fig. 25)

- Disconnect the electric battery at a long-term idleness of the device.

Any works regarding cleaning external parts of the vacuum cleaner are beyond the warranty service.

TROUBLESHOOTING

The Table contains the most usual problems which may arise during operation the device. Depending on a defect

reason, you can hear 1 to 4 beeps.