Maunfeld MBF177NFW [28/64] Troubleshooting

Maunfeld MBF177NFW [28/64] Troubleshooting
1131
28
Electrical connection - Troubleshooting
Green and
Yellow to Earth
Blue to
Neutral
13 amp Fuse
Brown
to Live
Cord Clamp
EN
WARNING: THIS APPLIANCE MUST BE EARTHED
If the appliance has been fitted with a non-rewirable plug of
the incorrect type for the mains socket, cut off the plug and fit
a new one. The removed plug must be thrown away. Inserting
an unsuitable plug into a 13 Amp socket is likely to cause an
electrical hazard. When a non rewirable plug or rewirable 13
Amp (BS1363) plug is used, it must be fitted with a 15 Amp
A.S.T.A. approved (BS1362) fuse. If any other type of plug is
used it must be wired as follows. Connect the GREEN & YEL-
LOW wire to the earth terminal marked with the letter “E” or
earth symbol, or coloured green or green & yellow. Connect
the BLUE wire to the neutral terminal marked with the letter
N” or coloured black. Connect the BROWN coloured wire to
the live terminal marked with the letter “L” or coloured red.
If the appliance has no plug attached, it must be
connected to the electricity supply by installing a
switch which is directly connected to the mains. This
switch must ensure omnipolar disconnection under
overvoltage category III conditions.
TROUBLESHOOTING
1) THE APPLIANCE DOES NOT WORK.
- Is there a power cut?
- Is the plug inserted properly in the mains socket?
- Is the power supply cable damaged?
- Is the temperature setting correct?.
2) THE TEMPERATURE INSIDE THE COMPARTMENTS IS NOT
LOW ENOUGH.
- Do the doors close properly?
- Is the appliance installed near to a heat source?
- Is the temperature setting correct?.
- Is the condenser clean?
3) THE TEMPERATURE INSIDE THE FRIDGE COMPARTMENT
IS TOO LOW.
- Is the thermostat in the right position?
4) THE APPLIANCE IS VERY NOISY.
- Is the appliance in contact with other furniture or objects?
- Are the pipes on the back touching or vibrating?
- Is the appliance level?
5) THE INTERNAL LIGHT DOES NOT WORK
- Contact the ASSISTANCE SERVICE.
6) WATER IS FOUND ON THE FLOOR.
- Is tray V placed correctly and contacting the compressor
surface?
- Is discharge tube R placed correctly inside the tray?

Содержание

Скачать