Luxstahl MARCO Qwikbrew-Twin Руководство по эксплуатации онлайн [4/8] 764007

1900064 REV.2 Page 4 of 8

 When the machine has enough water to brew coffee, the green ‘Ready to Brew’ lights

illuminate (after approximately 26-39 minutes depending on power). A brew can be

selected at this point, but the machine is NOT full yet and will continue to fill. After

approximately 34-50 minutes (depending on power) the heaters will shut off. The

machine is now full and up to temperature.

BREWING COFFEE:

 Slide out the coffee filter bowl and place a single sheet of filter paper in the bowl.

 Put the correct amount of ground coffee into the filter paper. Your coffee supply

company may have pack sizes to suit the brews of your new Qwikbrew 2 Twin; if not,

as an approximate guide for your first brews:

110g - 120g (4 - 4½oz) for a Half Brew (5 pints [2.85 litres])

220g - 240g (8 - 8½oz) for a Full Brew (10 pints [5.7 litres])

 Depending on the coffee grind and roast, and on water quality, you may have to adjust

these quantities to obtain the optimum flavour.

 Level off the surface of coffee by gently shaking the filter bowl. Slide the coffee filter

bowl into the guide rails in the brew head and push fully home.

 Select the correct brew on the relevant control panel (e.g. left control panel if the left

urn being used) by pressing either the Half Brew switch for a 5 pint brew or the Full

Brew switch for a 10 pint brew. Press the switch until the amber light illuminates. If you

make a mistake press the Power switch to turn the machine off. Wait 3 seconds and turn

back on again. Select the correct brew.

 A half brew should take around 4min - 4min 45secs. A full brew should take around

8mins - 9mins 30secs. These depend on the factory or default setting of the machine.

 Note: allow time for all the coffee to drain from the filter bowl before removing.

 As soon as possible after brewing – remove the filter paper with the spent grinds.