Luxstahl MARCO Qwikbrew-Twin [6/8] Note two flash and six flash error sequences will be displayed if there is low water pressure please check that there is water pressure and that the water stop valve...

1900064 REV.2 Page 6 of 8

TROUBLESHOOTING:

The Marco Qwikbrew 2 Twin uses an electronic diagnostic system to help determine faults.

If an error is detected a sequence of flashes is displayed through the POWER light. This

sequence is repeated (cycled) until:

1. The problem is rectified by a service agent, or

2. In the case of the 6 flash cycle – the machine senses that normal operation has resumed,

and the flash sequence ceases.

The number of flashes in a cycle corresponds to the symptom in the table on the following

page.

Note: Two flash and six flash error sequences will be displayed if there is low water

pressure. Please check that there is water pressure and that the water stop -valve is

open before calling your service agent.

Status/Diagnostic light guide:

No of flashes

Symptom

Action required

Water level below elements.

Normal when machine first

fills.

Check water pressure, if this is OK -

call service agent.

Temperature sensor failure (o/c)

Call service agent

Water not heating

Call service agent

Temperature sensor failure (s/c)

Call service agent

Machine not filling

Check water pressure. If this is OK

and the machine has not returned to

normal operation after 15 min – call

service agent