Home
Главная
Luxstahl
Водонагреватель
MARCO Ecosmart PB10
Руководство по эксплуатации Страница: 2

Luxstahl MARCO Ecosmart PB10 Руководство по эксплуатации онлайн [2/13] 764021

1900051 REV.3 Page 2 of 13

SAFETY:

 This appliance must be earthed.

 Risk of flooding. A hose is not supplied with this unit. When connecting to the water mains it

should be considered that a hose is not a permanent connection. It is, therefore, advisable to

switch off boiler and close the stopcock valve when boiler is not in use, e.g. overnight,

weekends etc.

 Risk of scalding. Beware of accidentally operating the water drawoff tap or push button

especially when cleaning the front of the boiler.

 The utmost care has been taken in the manufacture and testing of this unit. Failure to install,

maintain and / or operate this boiler according to the manufacturer’s instructions may result in

conditions that can cause injury or damage to property. If in any doubt about the serviceability

of the boiler always contact the manufacturer or your own supplier for advice.

 This appliance is not intended for use by persons (including children) with reduced physical,

sensory, or mental capabilities, or lack of experience and knowledge, unless they have been

given supervision or instruction concerning use of the appliance by a person responsible for

their safety.

 Children should be supervised to ensure that they do not play with the appliance.

 In the event any wires are damaged, such wires can only be replaced by experts or

professional after service staff from the manufacturer, after service department or similar

function departments.

INSTALLATION DETAILS:

Electrical installation:

 Electrical specification:

Machine type

Rated power

Plug type

Plumbing

1000677US

1000678US

2.9kW @ 240V

2.2kW @ 208V

50Hz / 60Hz

NEMA 6-15P or

NEMA L6-20P

(3/8" NPT)

1000677

1000678

2.8kW @ 230V

50Hz / 60Hz

BS 1363

(3/4" BSP)

1000677MJ

1000678MJ

2.8kW @ 200V

50Hz / 60Hz

(3/4" BSP)

Plumbing installation procedure:

 Mains water pressure required (limits): 5-50psi (35-345kPa).

 Fit a stop Valve on a cold water line and attach a suitable fitting.

 Connect a suitable hose to the stop valve fitting.

 Turn on the water to flush any impurities, dust etc from the inlet hose and water pipe. Allow

several gallons through. Especially for new installations.

 Connect the hose to the inlet valve of the boiler. Make sure a sealing washer is fitted.

 Turn on water and check for leaks.

Backflow Prevention:

 This equipment must be installed with adequate backflow protection to comply with all

applicable federal, state and local codes. US versions only.

Operating boiler for the first time:

 Check that all installation procedures have been carried out.

 Ensure water valve is on.

 Plug boiler into suitable socket.

Luxstahl MARCO Ecosmart PB10 Руководство по эксплуатации онлайн [2/13] 764021

Содержание

Похожие устройства