Delfa USI-191 [3/8] Cleaning

Shot of steam

Shot of steam give extra steam for removing persistent wrinkles.

1. Place the temperature selector at the “max” position and wait until the pilot light goes out

2. Wait for a few seconds for the steam to penetrate the fibre before pressing again.

NOTE: For the best steam quality, do not use more than three successive bursts each time. Several pumping

actions are needed to start this function.

Excessive use of this feature will cause the iron to cool, ensure that the pilot light is out, before

operating the shot of steam control

Cleaning

1. Disconnect the appliance from the mains, before cleaning.

2. Do not use solvents or abrasive products to clean the iron, clean with a damp cloth.

Faults-reasons and solutions

Iron emits an odor or smoke

Iron gives off an odor when turned on for the first time. Oils used during manufacture need to be burnt off allow ten

minutes for odor to disappear.

Iron does not heat

The iron should be plugged into 220-240 V, AC electrical outlet only. The temperature dial must be set at the

desired temperature.

Iron does not steam

The water tank many be empty. Turn the steam valve to “

“ and add water. Allow the iron to heat, and then set

the steam dial to the steam setting.

Burst of steam feature does not work

The water tank must be at least 1/4 full .Temperature must be set to steam position. Iron should be in the horizontal

position. Allow a short pause between shots. Be sure to fully depress the burst of steam button.

Spry mist feature does not work

The water tank must be at least 1/4 full. Fill the iron as described in the section “Filling the water tank”.

Iron is leaking

The steam switch should be set to the appropriate position. The heating controller should be in minimum position.

Specification.

Model: USI-191

Power supple: 230 V ~ 50 Hz

Power: 1400 W

The head office of the manufacturer : «UNIT Handelsgesellschaft G.m.b.H.»

131, Gersthofer Str., A-1180, Vienna, Austria

Exported by: «UNIT Electronics (H. K.) Limited»

3905 Two Exchange Square, 8 Connaught Place,

Central, Hong Kong