Efco Artik 56 (222859) [48/150] Rus uk

Efco Artik 56 (222859) [48/150] Rus uk
44
I
GB
F
D
E
SK
P
GR
TR
CZ
RUS
UK
PL
11. TROUBLESHOOTING
WARNING: always stop the machine and remove the engine key (5, Fig. 41) before carrying out any of
the corrective checks recommended in the table below, except when they require the unit to be in
operation.
When all the possible causes have been checked and the problem is not resolved, consult an Authorised Service
Centre. If a problem occurs that is not listed in this table, consult an Authorised Service Centre.
Problem Possible causes Solution
Engine fails to start There isn’t gasoline Fill the gasoline tank
Engine flooded See the procedure pag.36
Water in gasoline or old gasoline Drain tank and refil with fresh
gasoline
Spark plug dirty or defective Clean or replace
Low battery (56 EL) Recharge (pag.28)
Other Check carefully the start procedure
according to this manual, pag.35
Engine starts,but runs poorly Spark plug defective Replace
Gasoline cap vent is blocked Clean the vent
Drop in power of the engine Snow chute clogged Clean (pag.37)
Cutter and impeller clogged or
frozen
Clean
Speed to high Enter a lower gear (pag.37)
Cutter does not rotate Foreign bodies obstructing it Clean
Shear pins broken Replace (pag.40)
Cutter control cable incorrectly
adjusted
Adjust the cable (pag.40)
Drive belt cutter slide To adjust the belt and the pulley in
an Authorized Service Center
Drive belt cutter broken Replaced in an Authorized Service
Center
Cutter does not stop when the lever is
released.
NOTE: Turn off the engine
immediately
Drive belt cutter incorrectly adjusted To adjust the belt in an Authorized
Service Center
Pulley of the drive belt cutter
incorrectly adjusted
To adjust the pulley in an
Authorized Service Center
The traction does not work Traction control cable incorrectly
adjusted
Adjust the cable (pag.40)
Traction does not stop when the lever
is released.
NOTE: Turn off the engine
immediately
Drive belt traction incorrectly
adjusted
To adjust the belt in an Authorized
Service Center
Pulley of the drive belt traction
incorrectly adjusted
To adjust the pulley in an
Authorized Service Center
The machine veers to one side Tires pressure not equal Adjust the tires pressure (pag.34)
Skid plates incorrectly adjusted Adjust the skid plates and the
scraping blade (pag.33)
Scraping blade incorrectly adjusted Adjust the scraping blade and the
skid plates (pag.33)
There's traction on one wheel Check the machine in an
Authorized Service Center
The machine has strong vibrations.
NOTE: Turn off the engine
immediately
Cutter and impeller damaged Check the machine in an
Authorized Service Center
WARNING: Do not attempt to carry out repairs without the necessary repairs and technical expertise.
Poorly executed repairs will automatically invalidate the warranty and relieve the manufacturer of all
liability.

Содержание

Скачать