Fubag HONDA PTH 400H [11/26] Page10
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Fubag HONDA PTH 400H [11/26] Page10

Fubag PTH 600 ST [11/26] Page10

Содержание

Похожие устройства

Fubag Operator s manual www fubag ru Cleaning the air filter 1 Remove wing nut and coverfrom the air filter no 1 2 2 Remove the filter elements no 4 5 and clean them Paper element no 4 a Gently tap the element several times on a hard surface to remove any excess dirt OR Pass compressed air through the filter from the inside out Never try to remove dirt using a brush b Replace the paper element if it is too dirty Foam element no 5 a Wash the element in a solution of household cleaner and warm water and rinse thoroughly OR wash with non flammable solvent or solvent with a high flash point Allow the element to dry completely b Soak the element in clean engine oil and remove the excess oil Note If there is too much oil remaining in the foam the engine will emit smoke when it is first started 3 Check carefully that the two elements are not torn or pierced Replace them if they are damaged 4 Carry out refitting following the reverse procedure for removal Checking the spark plug 1 Remove the cap fig F no 1 from the spark plug then remove the spark plug fig F no 2 using a spark plug spanner 2 Check the condition of the spark plug If the electrodes are worn or if the insulation is split or flaking 3 Replace the spark plug 4 Fit a new spark plug in position and tighten it by hand to avoid damaging the threads 5 Use a spark plug spanner to tighten the spark plug by 1 2 turn after it is seated to compress the washer Otherwise 3 Clean the spark plug with a metal brush 4 With a feeler gauge check the electrode gap X it must be between 0 7 and 0 8 mm inclusive 5 Check the condition of the washer 6 Fit the spark plug in position and tighten it by hand to avoid damaging the threads 7 Use a spark plug spanner to tighten it by 1 8 1 4 turn after it is seated to compress the washer 10

Скачать