Pilotage Arrow 25 RC15831 [12/28] Troubleshooting guide
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Pilotage Arrow 25 RC15831 [12/28] Troubleshooting guide

Pilotage Arrow 25 RC15829 [12/28] Troubleshooting guide
11
TROUBLESHOOTING GUIDE
Problem Cause Solution
Boat will not respond to throttle
but responds to other controls
Throttle servo travel is lower than 100% Make sure throttle servo travel is 100% or greater
Throttle channel is reversed Reverse throttle channel on transmitter
Extra noise or extra vibration
Damaged propeller, shaft or motor Replace damaged parts
Propeller is out of balance Balance or replace propeller
Reduced runtime or boat
underpowered
Boat battery charge is low
Completely recharge battery
Boat battery is damaged
Replace boat battery and follow battery instructions
Blocking or friction on shaft or propeller Disassemble, lubricate and correctly align parts
Boat conditions may be too cold Make sure battery is warm before use
Battery capacity may be too low for conditions Replace battery or use a larger capacity battery
Drive dog is too close Loosen coupling at ex shaft and move out ex shaft
a small amount
Too little lubrication on ex shaft Fully lubricate ex shaft
Vegetation or other obstacles block the rudder or
propeller
Remove boat from the water and obstacles
Boat will not Bind (during
binding) to transmitter
Transmitter is too near boat during bind ing process Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large metal object Move boat or transmitter away from large metal
object
Bind plug is not installed correctly Install bind plug and bind boat to transmitter
Boat battery/transmitter battery charge is too low Replace/recharge batteries
ESC switch is o Power on ESC switch
Boat will not link (after binding) to
transmitter
Transmitter is too near boat during link ing process Move powered transmitter a few feet from boat,
disconnect and reconnect battery to boat
Boat or transmitter is too close to large metal object Move boat or transmitter away from large metal
object
Bind plug is left installed Rebind transmitter to boat and remove bind plug
before cycling power
Boat battery/transmitter battery charge is too low Replace/recharge batteries
Transmitter may have been bound to a dierent
model (using dierent DSM Protocol)
Bind boat to transmitter
ESC switch is o Power on ESC switch
Boat tends to dive in the water or
takes on water
The boat hull is not completely closed Dry out the boat and ensure the hatch is fully closed
on the hull before returning the boat to the water
Center of gravity is too far forward Move batteries back in the hull
Trim tabs are angled incorrectly on the back of the
boat
Angle each trim tab up a small amount to lift the bow
or down a small amount to lower the bow
Boat tends to turn one direction
Rudder or rudder trim is not centered Repair rudder or adjust rudder and rudder trim for
straight running when control is at neutral
Vertical ns of trim tabs are angled incorrectly Angle the ns a small amount right or left so that the
boat goes straight when the rudder is at neutral

Содержание

Похожие устройства

Скачать