Pilotage Arrow 25 RC15831 [9/28] Check lists

www.pilotage-rc.com

Before boating

• Install fully charged batteries in your boat and transmitter.

• Connect the boat’s battery to the ESC.

• Make sure the boat is bound to the transmitter (otherwise, bind the boat to the transmitter using the

included binding instructions).

• Make sure all linkages move freely on the boat.

• Ensure the motor mount is secured to the hull so that the motor does not move.

• Perform a Control Direction Test with the transmitter.

• Adjust the steering rate on your transmitter as desired.

• Find a safe and open boating area.

• Plan a safe boating route for the water and wind conditions.

After boating

• Always power o the receiver before powering o the transmitter to maintain control of the boat and to

retain transmitter binding.

• Disconnect the battery from the receiver and remove the batteries from the boat.

• Fully dry the inside and outside of the boat, including the water cooling lines and jackets around the motor

and ESC. Remove the hatch and radio box cover before storing your boat.

• Repair any damage or wear to the boat.

• Lubricate the ex shaft.

• Make note of lessons learned from the trimming of your boat, including water and wind conditions.

TIP!

The hook and loop strips in the boat retain water. To dry them, press on them with a dry cloth.

CHECK LISTS

NOTICE!

Running the boat in salt water could cause some parts to corrode. If you run the boat in salt water, rinse it

thoroughly in fresh water after each use and lubricate the drive system.

NOTICE!

Because of its corrosive eects, running RC boats in saltwater is at the discretion of the modeler.