De Dietrich DHD770X [10/15] Installation

The use of unused conduits is not permissible without the approval of a qualied tech-

nician. The minimum distance between the hob surface and the lowest part of the hood

must be 70 cm. IF the instructions for the cooker installed under the hood require an even

greater distance, this must take precedence.

- INSTALLATION

Beforeinstallingthehood,removetheanti-greaselterstoavoiddamagingtheappliance.To

removetheanti-greaselters,pushthehandletowardthelowerpartofthehoodandrotatethe

lterdownward,removingitfromitshousing(Fig.3A).

Wall stirrup-xing

Byusingthespecialdrillingjig(Fig.4X),perforatethewallaccordingtothepatternindicated

bythejigitself,andpayattentioninordernottodamagewaterpipesandelectricwires.Per-

forationshouldbeperformedwithaØ8mmwall-drill.Theninsertintotheproperplastic

reinforcements(Fig.4A).Thehood-bearingstirrup(Fig.5)canbeappliedbyusingthescrews

providedwiththeequipment(Fig.4S).Nowhookthecookerhoodontoitsbearing(Fig.4B)and

thenadjust horizontallyand verticallythe positionof theappliance byacting onthe special

metricscrews(Fig.7).

Fixing the ornamental chimney

Beforexingthechimney,placetheelectricfeedingequipmentintotheornamentalpipeand

provideitwithaholefortheairoutletiftheapplianceisusedinitssuckingversion.

Discharge mode

Attachthe hosewall mounttothewalland/orceilingwiththescrewexpandersandscrews

(Fig.8Y).Connecttheairdischargeangetothedischargeholewiththepurposehose.

Carryouttheelectricalhookup.Placethetwodecorativeuesonthesuctionunit.Raisethe

internalueuntilitmeetstheceilingandfastenittotheue-mountingunitwiththetwoself-

tappingscrewsincluded.

-Attachthesuctionunits(Fig.6)totheattachedwallmount.Usingtheadjustmentscrews(Fig.

7V),makesurethehoodislevel.

Recirculation mode

Attachthehosewallmounttothewalland/orceilingwiththescrewexpandersandscrews.

Attachtheairdeectortotheupperue(Fig.10)neartheholesmadeonthebackoftheue.

Connecttheairdischargeangetothedeectorwiththepurposehose.

Carryouttheelectricalhookup.

Placethetwouesonthesuctionunit.Adjusttheupperueuntilitmeetstheceilingandfa-

stenittotheue-mountingunitwiththetwoself-tappingscrewsincluded.

Special assembly steps for DHD770X DHD770GW hoods

Forthishood,proceedtoassembletheglasspanelbeforecommencingtheinstallation

-Placetheglass(Fig.14)inthebottompartofthemodulesothattheholesareinlinewiththe

holesinthehoodbody.

-Fasten theglass inplace usingthescrewsprovided anda screwdriver;do nottighten the

screwsexcessively.

Preparation of the fastening screws

Insertthechrome-platedscrew(14D)intotheTeonwasher(14C)andtheninsert thePVC

tube(14b).