Bugatti Blender Vela 4105 Swarovski [15/16] Cleaning and maintenance

ALWAYS UNPLUG THE BLENDER WHEN IT IS NOT IN USE AND BEFORE CLEANING. DO NOT UNPLUG THE

BLENDER BY PULLING ON THE CABLE.

DO NOT IMMERSE CABLES, PLUGS OR THE BLENDER IN WATER OR OTHER LIQUIDS, EITHER PARTIALLY

OR TOTALLY.

1) The blender must be unplugged from the socket before it is cleaned. Do not pull on the cable to unplug.

2) You are advised to clean the blender immediately after use.

3) Never leave the motor base (6) or the cable with plug (7) wet.

4) Clean the motor base (6) with a damp cloth and then dry. Do not use abrasive detergents.

5) Do not touch the blades. To clean, place them under running water and wipe with a brush. Leave them

to air dry. Keep children away from the blades: they can cause serious injury.

6) Before using the blender again, check that all its parts are correctly assembled and perfectly dry,

especially the motor base (6).

Only the jar, without the blade unit (5), can be washed in the dishwasher.

8) For a quick wash, pour a glass of hot water and a add a drop

of detergent into the jar. Place the lid (2)

and the measuring filler cup (1) into the jar and use the selector (12) to run the blender for at least 30

seconds. Drain the water from the jar and rinse it thoroughly before using it again.

Cleaning and maintenance

Troubleshooting.

If the Vela blender develops faults or defects or if irregularities are suspected, unplug it immediately.

If you cannot eliminate the fault by following the instructions in this manual, contact Customer Care

at CASA BUGATTI. Repairs carried out incorrectly can expose the user to serious harm. No liability is accepted

for damage or injury caused by repairs carried out incorrectly and in such cases warranty rights are

voided.

Vela Blender stop

functioning

Should the unit be

overheated (e.g.: over

heavy loading for long

time)

Vela Blender is well equipped with an over-temperature automatic

protection. This system will give much longer life to the motor of

your blender. Please unplug the unit and let it cold down for around

30-40 minutes. After cooling down the blender will be able

to operate again normally.

Trouble Possible Cause Solution