Hoover SM96WD4 011 [7/73] Features

3

FEATURES

STORAGE/CHARGING

UNIT STORAGE

The product is designed to sit in the charging base on a at surface or vertically if wall mounted. [1]

For tidy storage wrap excess cord on the back of the charging base and exit either side or bottom.

To Wall Mount (Tools required: Screwdriver and drill)

1. Place the cardboard ruler against the mounting surface. Mark the centres of the holes.

2. Move base then drill 4.8mm holes.

is fully charged and is still positioned on the charger base, the icon will stop ashing and remain lit.

For the cleaner without LED Display *. The charging LED indicator** will illuminate red all the time to advise that the product is

charging. When the product is fully charged and is still positioned on the charger base, the red led will remain on.

NOTE: Use only the charger supplied with your cleaner to recharge the unit.

IMPORTANT: Before rst use, charge your cleaner for at least 24 hours. When charging the cleaner, the power switch must be

o. It is normal for the charger to become warm to the touch when charging. If the operating time reduces after repeated use,

let the cleaner run until it stops, then recharge for 24 hours and repeat this monthly for best results. Never charge the batteries in

temperatures above 37°C or below 0°C.

1. Remove the cleaner from the storage base.

IMPORTANT: For best results clean the lter after each use.

A On/O Switch**

B LED Display*

C LED Charging Indicator**

E Suction Inlet

F Power Nozzle*

G Dust Bin Flap

H Charger Base

This cleaner is equipped with a LED display. When the product is on, the display will report following information:

Battery Level Indicator*:

•  4 bars = 100% charge

•  3 bars =  75% charge

•  2 bars =  50% charge

•  1 bar  =  25% charge

•  0 bar <=  5% charge

LED DISPLAY*

*certain models only ** May vary according to model