Denon DN-410x Руководство по эксплуатации онлайн [7/40] 776802

10. Stereo Aux Return: Connect the outputs of an external device to these inputs with 1/4”

(6.35mm) mono cables. This is usually reserved for outboard effects devices but can also

be used as an extra input channel for synthesizers, drum machines, etc. If your source is

mono, plug it into the left jack and it will be heard on both the left and right sides.

11. Ext In (RCA): These stereo RCA jacks accept consumer-level (-10dBv) inputs from

sources such as tape decks, CD players, and MP3 players. Only connect consumer-level

equipment to these jacks. Professional-level equipment operating at +4dBu will distort

unless you significantly lower the volume on such equipment.

12. Stereo Line Inputs: Connect line-level devices to these inputs with 1/4” (6.35mm)

cables.

Note: If you want to connect a standard turntable to DN-410X, use a dedicated turntable-

to-line-level preamplifier.

13. Mic/Line Inputs: Channels 1–4 of the mixer accept microphones via the XLR connectors

or mono line-level sources via the 1/4” (6.35mm) connectors. Channels 9/10 can be used

with the Ext In or with a paired Bluetooth device.

Warning: Channels 1–4 each have mic level and line level inputs. Attach either a

microphone or a 1/4” (6.35mm) cable to the mic/line channel, but do not attach both

cables to the same channel at any one time. In extreme cases, doing so can damage

your microphone.

14. Insert: 1/4” (6.35mm) TRS jacks on Channels 1–4 allow you to connect external

processors (gates, compressors, pitch correction devices, etc.) into the signal path of

these channels. The insert signal is brought into the channel directly after the preamplifier

(controlled with the Trim knob) and before the channel’s EQ and fader. The insert jacks

require use of an “insert” cable, which has a TRS (tip-ring-sleeve) connector on one end

for connection to DN-410X and two TS (tip-sleeve) connectors on the other end. Attach

the “send” connector to the input of your external processor. Then, attach the “return”

connector to the output of your processor. See the insert cable diagram under Multitrack

Audio Recording.