Home
Главная
Alto
DJ микшер
DJM-2
Руководство по эксплуатации Страница: 14

Alto DJM-2 [14/16] System block diagram

5. SYSTEM BLOCK DIAGRAM

Содержание

User s manual 1
A registered electrician 3
Always use proper ready made insulated mains 3
And when unused for long periods of time to reduce 3
Before turning the product on make sure that it is 3
Caution 3
Connected to ground this is to prevent the risk of 3
Cord is removed 3
Could result in fire 3
Covers should be removed by qualified service 3
Describes precautions that should be observed to 3
Do not block areas of ventilation failure to do so 3
Do not remove any covers 3
Do not use this product when in close proximity to 3
Electric shock 3
Ensure that the mains source voltage ac outlet 3
External connection 3
Ground terminal 3
Important safety instructions 3
In shock death or fire if in doubt seek advice from 3
Instructions 3
Keep product away from naked flames 3
Manual do not short circuit the fuse holder before 3
May present to reduce the risk of electric shock do 3
Never cut internal or external ground wires likewise 3
Never remove ground wiring from the protective 3
No user serviceable parts inside 3
Not remove any covers unless the ac mains power 3
Off and disconnected from the ac outlet 3
Personnel only 3
Possibly the user 3
Power supply 3
Prevent damage to the product 3
Prevent the possibility of death or injury to the user 3
Protect the power cord and plug from any physical 3
Replacing the fuse make sure that the product is 3
Safety related symbols 3
The recommended fuse type as indicated in this 3
The risk of electric shock or fire 3
To avoid the risk of electric shock and damage do 3
To do so could result in damage to the product and 3
Warning 3
Preface 4
Ac inlet and fuse holder 5
Control elements 5
Introduction 5
Main out 5
Mic in jack 5
Power switch 5
Table of contents 5
The channel section 5
The front panel 5
The phone out jack 5
The top cover 5
Features list 6
Introduction 6
Control elements 7
Pgm 2 pgm 1 7
The top cover 7
Channel but do not turn it too much counterclockwise 8
If you set the curve switch on sharp position the 8
20 21 22 23 11
Mic in jack 11
The front panel 11
The phone out jack 11
The rear panel 11
This input will accept a standard headphone with a 1 4 stereo jack 11
This input will accept any unbalanced low impedance microphone the functions of the microphone will be controlled by the mic main section on the top panel 11
Technical specifications 13
System block diagram 14
Of 1 year from the purchase date if you have completed the warranty registration card in time 15
Retail dealer and it can not be transferred 15
The warranty service is only available to the original consumer who purchased this product directly from the 15
This warranty gives you the specific rights and these rights are compatible with the state laws you may also 15
Warrants that this product will be free from any defects in materials and or workmanship for a period 15
Warranty 15
All rights reserved to alto all features and content might be changed without prior notice any photocopy translation or reproduction of part of this manual without written permission is forbidden copyright 2005 seikaku group 16

Alto DJM-2 [14/16] System block diagram

Содержание

Похожие устройства