JBL CONTROL 19 CST [7/19] Step by step installation and wiring

STEP-BY-STEP

INSTALLATION AND WIRING

The installation system has been designed so that the entire installation can be

accomplished from beneath the ceiling, for instances when access above the tile is not

possible or practical. However, in some cases it may be easier with removable ceiling

tiles to access from both the top and bottom of the ceiling tile during various phases of

the installation.

Step 1 – Cut the Hole.

Cutout the hole size either by tracing the cardboard cutout

template or with a circular cutter set to the cutout sizes listed above. Pull the wiring

through the cutout hole.

Step 2 – Insert Backing Hardware Through the Hole.

Packaged with the speakers

are two types of backing hardware – a C-shaped backing-plate bracket and two tile

rails.

Suspended Ceilings –

Insert the C-plate through the hole cut in the ceiling tile.

Place the C-plate around the hole with the tabs located as shown on Figure 4.

Insert the tile rails through the cut hole in the ceiling tile. Snap the two rails into the

two tabs in the C-plate and align the rails so that the ends extend OVER the T-

channel grid on the side of the tile. Secure the rails onto the C-bracket tabs by

inserting a screw though each tab into the rail. This can all be accomplished from

below the ceiling tile, if necessary.

 !"#

ALL included support brackets – C-plate and tile rails -- MUST be used

when installing into suspended ceiling tiles.

Figure 3:

Hole Cutout