ADJ Ruby Royal [3/12] Operation instructions and laser safety
![ADJ Ruby Royal [3/12] Operation instructions and laser safety](/views2/2009640/page3/bg3.png)
©American DJ® - www.americandj.com - Ruby Royal Instruction Manual Page 5
©American DJ® - www.americandj.com - Ruby Royal Instruction Manual Page 6
Ruby Royal Laser Warnings and Safety
NON-INTERLOCKED HOUSING WARNING
The Ruby Royal contains high power laser devices internally. Do not
open the laser housing, due to the potential exposure to unsafe levels
of laser radiation. The laser power levels, if the unit is opened, can
cause instant blindness, skin burns and res.
STOP AND READ ALL LASER SAFETY DATA
OPERATION INSTRUCTIONS AND LASER SAFETY
The light source emitted from this product can potentially cause eye
injury if not set up and used properly. The light source emitted from a
laser is very dierent from any other light sources with which you may
be aware of. Laser light is thousands of times more concentrated
than any light from any other kind of light source. This concentration
of light can cause instant eye injuries, primarily by burning the retina
(the back of your eyeball contatining cells that are sensitive to light).
Even if you cannot feel “heat” from a laser beam, it can still poten-
tially injure or blind you or your audience. Even very small amounts
of laser beam light are potentially hazardous even at long distances.
Laser eye injuries can be sustained faster than you can blink.
Do not think that because this laser splits the laser beam into hun-
dreds of beams and that the laser beam is scanned out in high
speed, that an individual laser beam is safe for eye exposure. This
laser uses dozens of milliwatts of laser power (Class 3B levels inter-
nally) before it splits into multiple beams (Class 3R levels). Many of
the individual beams are potentially hazardous to the eyes.
Do not that because the laser light is moving, it is safe. This is not
true. Nor, do the laser beams always move. Since eye injuries can
occur instantly, it is critical to prevent even the smallest possibility of
any direct eye exposure. In the laser safety regulation, it is not legal
to aim Class 3R lasers in areas which people can get exposed. This
is true even if it is aimed below people’s faces, such as on a dance
oor.
Do not operate the laser without rst reading and understanding
all safety and technical data in this manual.
Always set up and install all laser eects so that all laser light is at
least 3 meters (9.8 feet) above the oor on which people can stand.
After setting up, and before public use, test laser to ensure proper
function. Do not use if any defect is detected. Do not use if laser
emits only one or two laser beams rather than dozens/hundreds, as
this could indicate damage to the diraction grating optic, and could
allow emission of higher laser levels above Class 3R.
Do not point lasers at people or animals. Never look into the laser
aperture or laser beams.
Do not point lasers in areas in which people can potentially get
exposed, such as uncontrolled balconies, etc.
Do not point lasers at highly reective surfaces, such as windows,
mirrors and shiny metal. Even laser reections can be hazardous.
Never point a laser at aircraft, this is a federal oense.
Never point un-terminated laser beams into the sky.
Do not expose the output optic (aperture) to cleaning chemicals.
Do not use laser if the laser appears to be emitting only one or two
beams.
Do not use the laser if the housing is damaged, the housing is open,
or if the optics appear damaged in any way.
Never open the laser housing. The high laser power levels inside of
the protective housing can start res, burn skin and will cause instant
eye injury.
Never leave this device running unattended.
The operation of a class 3R laser show is only allowed if the show
is controlled by a skilled and well- trained operator, familiar with the
data included in this manual.
The legal requirements for using laser entertainment products vary
from country to country. The user is responsible for the legal require-
ments at the location/country of use.
Always use proper lighting safety cables when hanging lights and
eects overhead.
Ruby Royal Laser Warnings and Safety
Содержание
- Caution 1
- User instructions 1
- Warning 1
- Operation instructions and laser safety 3
- Stop and read all laser safety data 3
- Dmx 512 4
- Power supply 4
- Be sure to follow figures two and three when making your own cables do not use the ground lug on the xlr connector do not con nect the cable s shield conductor to the ground lug or allow the shield conductor to come in contact with the xlr s outer casing grounding the shield could cause a short circuit and erratic behavior 5
- Conductor 5 pin xlr male in 3 pin xlr female out 5
- Data compliment signal 5
- Data true signal 5
- Dmx cable must be daisy chained and cannot be split 5
- Ground shield 5
- Not used 5
- Notice 5
- Pin 4 do not use 5
- Pin 5 do not use 5
- Pin xlr dmx connectors 5
- Pin xlr to 5 pin xlr conversion 5
- Ruby royal set up 5
- Some manufactures use 5 pin dmx 512 data cables for data transmission in place of 3 pin 5 pin dmx fixtures may be implemented in a 3 pin dmx line when inserting stan dard 5 pin data cables in to a 3 pin line a cable adaptor must be used these adaptors are readily available at most electric stores the chart below details a proper cable conversion 5
- Special note line termination 5
- When longer runs of cable are used you may need to use a terminator on the last unit to avoid erratic behavior a terminator is a 110 120 ohm 1 4 watt resistor which is con nected between pins 2 and 3 of a male xlr connector data and data this unit is inserted in the female xlr connector of the last unit in your daisy chain to terminate the line using a cable terminator adj part number z dmx t will decrease the possibilities of erratic behavior 5
- Dmx address setting via control board 6
- In this mode you can run in sound active mode 6
- Set a unit as a slave in a master slave configura tion 6
- Shnd sh 0 sh 1 6
- Show modes 0 18 show mode can run with or without sound active mode activated 6
- Sound sensitivity control 7
- This function will allow you to test the pan tilt functions 7
- This function will flip the led display 180º 7
- This will control blackout 7
- This will display the software version 7
- Use this function to reset the unit 7
- With this function the led display will turn off after 2 minutes 7
- With this function you can display the running time of the unit 7
- Master slave configuration 8
- Operating modes the ruby royal has three different operat ing modes 8
- Shnd is displayed and press enter 8
- Show mode stand alone or master slave 8
- Sound active mode stand alone or master slave 8
- Universal dmx control 8
- Always be sure to dry all parts completely before plugging the unit back in 10
- American d 10
- Be sure the fuse holder is completely and properly seated 4 be sure the unit is not in blackout mode unit does not respond to sound 10
- Be sure you have turned on the unit 2 be sure the external fuse has not blown the fuse is located on the rear panel of the unit 10
- Clean the external optics with glass cleaner and a soft cloth every 20 days 10
- Cleaning frequency depends on the environment in which the fixture operates i e smoke fog residue dust dew in heavy use we recom mend cleaning on a monthly basis periodic cleaning will ensure lon gevity and crisp beam output 10
- Due to fog residue smoke and dust cleaning the internal and external lenses should be carried out periodically to optimize light output 1 use normal glass cleaner and a soft cloth to wipe down the out side casing 10
- Fixture cleaning 10
- Locate and remove the unit s power cord once the cord has been removed located the fuse holder located inside the power socket insert a flat head screw driver into the power socket and gently pry out the fuse holder remove the bad fuse and replace with a new one the fuse holder has a built in socket for a spare fuse be sure not to confuse the spare fuse with active fuse 10
- Low frequencies bass should cause the unit to react to sound tapping on the microphone quiet or high pitched sounds may 10
- No laser output from the unit 10
- Not activate the unit not activate the unit 10
- Ruby royal cleaning 10
- Ruby royal fuse replacement 10
- Ruby royal trouble shooting 10
- Ruby royal warranty 10
- Trouble shooting listed below are a few common problems that you may encounter with solutions 10
- Www americandj com ruby royal instruction manual page 19 10
- Www americandj com ruby royal instruction manual page 20 10
- American dj europe 12
- American dj supply 12
- American dj world headquarters 12
- Auto sensing voltage 12
- Ew kerkrade 12
- Junostraat 2 12
- Model ruby royal 12
- Netherlands 12
- Please note 12
- S eastern ave los angeles ca 90040 usa 12
- Service adjgroup eu www americandj eu 12
- Specifications and improvements in the design of this unit and this manual are subject to change without any prior written notice 12
- Tel 31 45 546 85 00 fax 31 45 546 85 99 12
- Tel 323 582 2650 fax 323 582 2610 12
- This fixture contains a automatic volt age switch which will auto sense the voltage when it is plugged into the power source 12
- Web www americandj com e mail info americandj com 12
Похожие устройства
- JENSEN LOUDSPEAKERS P12Q (8 Ohm) Руководство по эксплуатации
- JENSEN LOUDSPEAKERS P12Q (16 Ohm) Руководство по эксплуатации
- AKG Y45 BT Инструкция по эксплуатации
- Ion Audio MOTION DELUXE Инструкция по эксплуатации
- Invotone SYSTEMDRIVE206 Руководство по эксплуатации
- Invotone MX6FX Руководство по эксплуатации
- Invotone MX12FX Руководство по эксплуатации
- Invotone MOD2800LV Руководство по эксплуатации
- Invotone MOD126LV Руководство по эксплуатации
- Invotone MOD2800HS Руководство по эксплуатации
- Invotone IPS16A Руководство по эксплуатации
- Invotone MOD126HH Руководство по эксплуатации
- Involight SLIMPAR784 Руководство по эксплуатации
- Involight SBL2000 Руководство по эксплуатации
- Involight SBL1000HP Руководство по эксплуатации
- ES-ACOUSTIC 115S P4 Руководство по эксплуатации
- Alto L-16MKII Руководство по эксплуатации
- Behringer EUROPOWER PMP 4000 Руководство по эксплуатации
- Behringer ULTRATONE KT 108 Руководство по эксплуатации
- Behringer EURODESK SX 2442FX Руководство по эксплуатации