Infiniti G35 Sedan (2007) [388/408] Installing front license plate

Use the following steps to mount the li-

cense plate:

Before mounting the license plate, con-

firm that the following parts are enclosed

in the plastic bag.

Only use the recommended mounting po-

sition or Intelligent Cruise Control (ICC)

sensor obstruction (if so equipped) may

result.

O License plate bracket

O J-nut x 2

O Screw x 2

O Screw grommet x 2

1. Temporarily place the license plate

bracket while aligning the lines

be-

hind the top of the front bumper

opening with part

of the rear sur-

face of the license plate bracket.

2. To determine where to drill the hole,

mark along both sides of the

mounting hole by using a felt-tip pen.

3. Remove the license plate bracket and

connect the arcs to form ovals. Mark

the point in the center of each oval.

These are the pilot drilling locations.

4. Carefully drill two pilot holes using a

STI0496

INSTALLING FRONT LICENSE PLATE

9-12 Technical and consumer information

w 06.7.27/V36-D X