Infiniti G35 Coupe (2006) [121/344] Button
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Infiniti G35 Coupe (2006) [121/344] Button

Infiniti G35 Coupe (2006) [121/344] Button
tinue to push and hold the HomeLink
button (note steps 2 through 4 under
“Programming HomeLink
”) while you
push and re-push (“cycle”) your hand-
held transmitter every 2 seconds until the
indicator light flashes rapidly (indicating
successful programming).
NOTE:
If programming a garage door opener, etc.,
it is advised to unplug the device during
the “cycling” process to prevent possible
damage to the garage door opener compo-
nents.
OPERATING THE HomeLink
UNIVERSAL TRANSCEIVER
The HomeLink Universal Transceiver
(once programmed) may now be used to
activate the garage door, etc. To operate,
simply push the appropriate programmed
HomeLink
Universal Transceiver button.
The red indicator light will illuminate
while the signal is being transmitted.
PROGRAMMING
TROUBLE-DIAGNOSIS
If the HomeLink does not quickly learn
the hand-held transmitter information:
O replace the hand-held transmitter bat-
teries with new batteries.
O position the hand-held transmitter
with its battery area facing away from
the HomeLink
surface.
O push and hold both the HomeLink
and hand-held transmitter buttons
without interruption.
O position the hand-held transmitter 2
to 5 inches (50 to 127 mm) away from
the HomeLink
surface. Hold the
transmitter in that position for up to 15
seconds. If HomeLink
is not pro-
grammed within that time, try holding
the transmitter in another position -
keeping the indicator light in view at
all times.
If you continue to have programming diffi-
culties, please contact the INFINITI Con-
sumer Affairs Department. The phone
numbers are located in the Foreword of
this Owner’s Manual.
CLEARING THE PROGRAMMED
INFORMATION
Individual buttons cannot be cleared,
however to clear all programming, push
and hold the two outside buttons and re-
lease when the indicator light begins to
flash (approximately 20 seconds).
REPROGRAMMING A SINGLE
HomeLink
BUTTON
To reprogram a HomeLink Universal
Transceiver button, complete the fol-
lowing.
1. Push and hold the desired HomeLink
button. Do not release the button until
step 4 has been completed.
2. When the indicator light begins to
flash slowly (after 20 seconds), posi-
tion the hand-held transmitter 2 to 5
inches (50 to 127 mm) away from the
HomeLink
surface.
3. Push and hold the hand-held trans-
mitter button.
4. The HomeLink
indicator light will
flash, first slowly and then rapidly.
When the indicator light begins to
flash rapidly, release both buttons.
The HomeLink
Universal Transceiver but-
ton has now been reprogrammed. The
new device can be activated by pushing
the HomeLink
button that was just pro-
grammed. This procedure will not affect
any other programmed HomeLink
but-
tons.
Instruments and controls 2-49
w 06.1.4/V35-D/V5.0 X

Содержание

Похожие устройства

Скачать