Infiniti G35 Coupe (2006) [87/344] Cruise set switch indicator light
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Infiniti G35 Coupe (2006) [87/344] Cruise set switch indicator light

Infiniti G35 Coupe (2006) [87/344] Cruise set switch indicator light
Cruise set switch indicator
light
The light comes on while the vehicle
speed is controlled by the cruise control
system. If the light blinks while the en-
gine is running, it may indicate the cruise
control system is not functioning prop-
erly. Have the system checked by an
INFINITI dealer.
Front passenger air bag
status light
The front passenger air bag status light,
located on the center display, will be lit
and the passenger front air bag will be off
depending on how the front passenger
seat is being used.
For front passenger air bag status light
operation, see “INFINITI advanced air bag
system” in the “1. Safety — Seats, seat
belts and supplemental restraint system”
section of this manual.
High beam indicator light
(Blue)
This light comes on when the headlight
high beam is on and goes out when the
low beam is selected.
Malfunction indicator lamp
(MIL)
If the malfunction indicator lamp (MIL)
comes on steady or blinks while the en-
gine is running, it may indicate a poten-
tial emission control malfunction.
The malfunction indicator lamp may also
come on steady if the fuel-filler cap is
loose or missing, or if the vehicle runs out
of fuel. Check to make sure the fuel-filler
cap is installed and closed tightly, and
that the vehicle has at least three gallons
(14 liters) of fuel in the fuel tank.
After a few driving trips, the
lamp
should turn off if no other potential emis-
sion control system malfunction exists.
If this indicator lamp comes on steady for
20 seconds and then blinks for 10 sec-
onds when the engine is not running, it
indicates that the vehicle is not ready for
an emission control system inspection/
maintenance test. See “Readiness for
inspection/maintenance (I/M) test” in the
“9. Technical and consumer information”
section of this manual.
Operation
The malfunction indicator lamp will come
on in one of two ways:
O Malfunction indicator lamp on steady
— An emission control system mal-
function has been detected. Check the
fuel-filler cap. If the fuel-filler cap is
loose or missing, tighten or install the
cap and continue to drive the vehicle.
The
lamp should turn off after a
few driving trips. If the
lamp
does not turn off after a few driving
trips, have the vehicle inspected by an
INFINITI dealer. You do not need to
have your vehicle towed to the re-
tailer.
O Malfunction indicator lamp blinking —
An engine misfire has been detected
which may damage the emission con-
trol system. To reduce or avoid emis-
sion control system damage:
a) Do not drive at speeds above 45
MPH (72 km/h).
b) Avoid hard acceleration or decel-
eration.
c) Avoid steep uphill grades.
d) If possible, reduce the amount of
cargo being hauled or towed.
The malfunction indicator lamp may
stop blinking and come on steady.
Instruments and controls 2-15
w 06.1.4/V35-D/V5.0 X

Содержание

Похожие устройства

Скачать