A.M.E. ММ-1 [9/29] Installer software switches just for reference
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

A.M.E. ММ-1 [9/29] Installer software switches just for reference

A.M.E. ММ-1 [9/29] Installer software switches just for reference
User’s Guide
AME MM1 Car Alarm System
8
Installer Software Switches (Just for Reference)
WARNING! Never change the settings of the Installer Functions! If any readjusting is required contact your
installation shop.
*NOTE:
WARNING: The Shock Sensor can be adjusted to operate as either onestage or twostage Sensor. To have
onestage Shock Sensor set the same level of sensitivity for both PreWarn and Main Trigger; for getting
twostage Sensor set the PreWarn Trigger sensitivity at least one level Higher than Main Trigger sensitivity.
1. Once you reach the highest or the lowest sensitivity, no further siren beeps will confirm any further pressings
of the transmitter button.
2. The PreWarn Trigger Sensitivity cannot be set less than the Main Trigger Sensitivity.
3. If you enter the setting, and do not press a transmitter button, the system will exit the setting after 1 minute
automatically and the sensitivity will stay at the previous setting.
**NOTE: If the PreWarn option is set and alarm system is armed with the door open (interior light switched on)
the input will be enabled in 15 seconds after the door is closed (interior light has turned off).
Software Function Default Setting Option 1 Option 2
Switch
1 Dome Light Cars OFF ON OFF
2 Door (+/) Input Polarity Negative Positive Negative
3 CDL Locking Time 0.8s 0.8s 4s
4 Twenty Second Locking OFF ON OFF
5* Shock Sensor Main Trigger Sensitivity 5 Up Down
1 = Minimum Sensitivity (A single beep (A double beep
10 = Maximum Sensitivity will confirm will confirm
LED will flash according to the current setting when each pressing) each pressing)
the switch is selected.
Press buttons 1 and 2 together to enter the setting.
When required sensitivity is set press buttons 1 and 2
once again to confirm and exit the setting.
Shock Sensor will be in a test mode when this
switch is selected to allow testing sensitivity.
6* Shock Sensor PreWarn Trigger Sensitivity 5 Up Down
1 = Minimum Sensitivity (A single beep (A double beep
10 = Maximum Sensitivity will confirm will confirm
LED will flash according to the current setting when each pressing) each pressing)
the switch is selected.
Press buttons 1 and 2 together to enter the setting.
When required sensitivity is set press buttons 1 and 2
once again to confirm and exit the setting.
Shock Sensor will be in a test mode when this
switch is selected to allow testing sensitivity.
7** Trunk ()/PreWarn() Input Trunk () Trunk () PreWarn

Содержание

Похожие устройства

Скачать