Caso HW 1000 [34/107] Please note

4. First press about 3-5 seconds. and light up.

5. Press to choose your desired temperature and press to set the water volume.

6. Press to operate the device. The desired water will flow out continuously from water

spout.

Press again, when your desired amount of water is dispensed.

The device will stop working at once.

7. If you want to dispense water again, repeat the steps above.

Please note

► If device was not used for longer time there could be scale deposits despite water filter. In

this case let 100 ml with 100 °C run through the device.

► The appliance has a memory function if the plug is still plugged in. The settings, that were

adjusted the last time, are still adjusted. The settings will be reset after unplugging.

► The ambient temperature changes everyday. This leads to different amounts of water. It

can vary up to +- 15%.

14.2.1 Water disposal from the drip tray

1. When the drip tray is full, grasp and stabilize the device by one

hand and use the other hand to lift up the drip tray slightly to

remove it.

2. Empty the drip tray and insert it into the original place. Make

sure it is properly inserted.

14.2.2 Replacing the waterfilter

1. Open the tank cover (A) and take out the filter

box (B) with the old waterfilter (C).

2. Soak the new waterfilter upright in water for 10

min.

3. Rinse the new waterfilter thoroughly under

running water.

4. Remove the old waterfilter and replace it with

the new waterfilter (see fig.). Therefor take out the

filter box, place the new waterfilter and pull it down

from the bottom.

14.2.3 Error code Lo

If the appliance stops to operate with a beeping sound and the display shows the error code

Lo, it means that there is too little water or no water in the water tank. Please fill in enough

water into the water tank immediately.