Stihl HLE 71 [16/28] Overload cutout lubricating the gearbox
Макгруп McGrp.ru
Задайте вопрос
Зарегистрироваться

Stihl HLE 71 [16/28] Overload cutout lubricating the gearbox

Stihl HLE 71 [16/28] Overload cutout lubricating the gearbox
HLE 71, HLE 71K
English
14
The machine is equipped with an
overload cutout.
The overload cutout disconnects the
power supply in the event of mechanical
overload, e. g., due to
– Excessive feed effort
– "Killing" of the motor speed
– Pinching of the trimmer blades in
the cut
If the overload cutout has disconnected
the power:
N Remove the trimmer blades from
the cut
N Wait for approx. 3 minutes until the
overload cutout has cooled down
Do not switch on the machine during this
time, because this substantially extends
the cooling down period.
Once the machine starts again:
N Let the machine run for approx.
15 seconds without load – this cools
the windings of the motor and
substantially delays renewed
triggering of the overload cutout
Blade drive
For the blade drive, use STIHL gear
lubricant for hedge trimmers (special
accessory).
N Check lubricant filling periodically
and after approx. every 25 hours of
operation
N Unscrew the locking screw (1) – if
no lubricant is visible on the inside
of it, then screw in the lubricant tube
N Squeeze up to 5 g of lubricant into
the gear unit
NOTICE
Do not completely fill the gear unit with
lubricant.
N Unscrew lubricant tube
N Refit locking screw (1) and tighten
securely
Angle drive
For the angle drive, use STIHL gear
lubricant for hedge trimmers (special
accessory).
N Check lubricant filling periodically
and after approx. every 25 hours of
operation
N Unscrew the locking screw (2) – if
no lubricant is visible on the inside
of it, then screw in the lubricant tube
N Squeeze up to 5 g of lubricant into
the gear unit
NOTICE
Do not completely fill the gear unit with
lubricant.
N Unscrew lubricant tube
N Refit locking screw (2) and tighten
securely
Overload Cutout Lubricating the Gearbox

Содержание

Похожие устройства

Скачать