Soundmax SM-CSL693 [4/16] Securing the speakers

If it is necessary to cut steel, reinstall the cosmetic panel

in place and use the hole you have previously cut as a

template. This will help to insure proper cutting and a good

fit. Now, mark the locations for the speakers mounting

screws, remove the panel and drill the screw holes. When

finished you may replace the panel.

After cutting and drilling all holes, inspect the mounting

areas for any metal burrs or rough edges. File any area that

may interfere with the mounting of the speaker.

Clean any metal shavings from the mounting area and

check for areas in which water may get inside the speaker.

Waterproof those areas when necessary.

Securing the speakers

Position the speaker into the mounting hole and re-confirm its proper

mounting location and hole placement.

Screw clips are provided to ensure a snug fit. These should be placed over

the metal surface and line up the hole you have previously drilled with the

screw clip. Place the speaker into the hole, align the holes and proceed to insert

the screws. Be sure to tighten the screws evenly so that it will not warp the

speaker frame.

Turn your system back on and confirm the speakers operation first at a low

volume and then you may increase the volume as you desire.